Tannoy V8 User Manual - page 8
12.5 SECUR – ET VTH Pole Mount
12.6 SECUR – ET VCS Ceiling Saddle
12.7 SECUR – ET VPC Pole Clamp
The Tannoy V8 loudspeaker is fitted as
standard with a metal blanking plate on the
base of the cabinet. However, should you
ever wish to mount the V18 onto a standard
35mm pole mount this blanking plate can be
quickly and easily removed and replaced by
a VTH pole mount. The same screws which
secure the blanking plate should be used to
secure the VTH in position.
Fig 1.
The VPC pole clamp can be used along with the
V8Y, VCB2 & VCB4 to suspend a Tannoy V8
loudspeakers from an overhead bar, truss or
suitable structure.
The following items are included with each
VPC:-
Description Quantity
VPC Pole Clamp
1
M10 Washer
1
M10 x 50mm Screw
1
M10 Nyloc Nut (Black)
1
Te VCS ceiling saddle available in both
black and white finishes, and is to be
used in conjunction with the V8Y, VCB2,
VCB4 and a length of M10 threaded rod
(not supplied by Tannoy Limited). The
VCS ceiling saddle allows the Tannoy V8
loudspeaker to be suspended at a user
defined distance from the ceiling as
shown in Figure 1.
Included with the VCS is an M10 nut. This
should be used to secure and lock the
threaded rod in place at the top of the
ceiling saddle.
VCS
10. Performance Data
Unprocessed Anechoic Frequency Response, 1 watt @ 1 metre
Impedance
A comprehensive range of measurements including off axis frequency response curves, octave & third octave
polar diagrams (single & two cabinet arrays) and beamwidth plots as well as Ease data can be downloaded
from
http://www.tannoy.com/
Enfocus Software - Customer Support