Taoglas CSB.01 Operators Manual And Installation Manual - 5. Installation With An
5. Installation with an
SMA Device - Mobile Location
1. If connecting to a Cellular Modem or
Mobile Data Terminal (e.g. Raven X,
etc) in a vehicle or mobile application,
connect the SMA to SMA device cable
(#5 on Parts List) to the Taoglas
Amplifier connector marked “Device”.
2. Connect the SMA end of the SMA-to-
SMA device cable to the Cellular
Modem or MDT antenna connection.
3. Mount the Outdoor Signal Antenna
(#4 on Parts List) vertically on any
metal surface on the roof, hood or
trunk of the vehicle.
4. Connect the Outdoor Signal Antenna
connector to the Taoglas amplifier
SMA connector marked “Antenna”.
5. Plug the 12V Hardwire DC Cable
(#3 on Parts List) into the vehicle fuse
block. You must connect the red wire
to a positive terminal from the fuse
panel with a 3 ampere fuse rating.
The black wire should be attached to
a ground of the vehicle. Power may
also be provided to the amplifier using
a 12V cigarette lighter adaptor.
(Not included)
6. Insert the Hard Wire DC Cable
connector plug into the amplifier and
watch the LED indicators.