Tapworks AD11 User And Installation Instructions Manual - Finishing Installation
15
Finishing installation
6 The complete recharge process will take about 1 hour.
As the recharge finishes water will run to drain. Check your
drain connections
7 Softened water will gradually replace the hard water in the storage
tank over a period of normally 7 days. However, this can take
longer in larger houses.
• Please leave this handbook for the water softener owner
• Please complete the enclosed Guarantee Registration Card
• Remember reward points are available to plumbers who are
members of the Team Tapworks Rewards Scheme.
IMPORTANT - TAPWORKS WATER SOFTENERS HAVE 12
MONTHS PARTS AND LABOUR WARRANTY. YOU CAN
EXTEND THIS TO 2 YEARS BY RETURNING THE GUARANTEE
REGISTRATION CARD. WE WILL SEND YOU (WITHIN 28
DAYS) YOUR WARRANTY CERTIFICATE DETAILING
YOUR 2 YEAR GUARANTEE.
Thank you for choosing Tapworks.
Your unit should now be fully plumbed and ready to use.
Having programmed your unit you will wish to ensure that the unit is
functioning properly before you leave the site.
NOTES TO THE INSTALLER – BEFORE YOU LEAVE
1 Open the inlet and outlet valve and close the bypass as indicated
in the diagram (page 7)
2 Check that all the plumbing connections are secure and that there
are no leaks
3 Check that the time of day is correct
4 Fill with salt - you will require a 25kg bag of tablet or pellet salt.
DO NOT USE GRANULAR SALT. Make sure that the brine well
cover is in place and secure as salt must not be allowed to enter the
brine well. Do not fill salt above the brine well cover
(See diagram page 3)
5 Initiate a recharge by holding down the TOUCH/HOLD button for
about 3 seconds until RECHARGE flashes in the display. After a
few minutes a small amount of water will enter the salt cabinet.
This part of the recharge will take approximately 4-8 minutes
Please Remember – Only use tablet or pellet salt in your softener!