Tascam US-122MKII Release Note - Release Notes
Firmware: 2.03, Windows driver: 2.03 (32 bit)/2.03 (64 bit), Mac OS X driver: 2.00
3
TASCAM US-122mkII/US-144mkII
Release Notes
How to install drivers and
firmware
Follow the procedures below to install the latest driver
and then update the firmware.
Windows
Before beginning installation, disconnect the US-122MKII
or US-144MKII from the USB cable.
1 Download the latest driver (Ver. 2.03 driver) for
your operating system from the TASCAM website
(http://tascam.com/), and save it to your comput-
er’s hard disk.
2 Uncompress the driver
zip
file on the hard disk.
3 Double-click the
setup.exe
file to start installation.
Follow the procedures in the Owner’s Manual to
complete the installation.
After completing installation of the driver and
restarting the computer, update the firmware.
4 Download the latest firmware (Ver. 2.03 firmware
updater (Windows)) for your operating system
from the TASCAM website (http://tascam.com/) and
save it to your computer’s hard disk.
5 Uncompress the saved
zip
file, and double-click the
exe
file that appears to start the firmware updater.
6 Connect the US-122MKII or US-144MKII to the
computer by USB, and confirm that
connected
appears on the updater screen.
7 Click the
write firmware
button to start the update.
CAUTION
Do not disconnect the USB cable during the update.
8 When the following message appears after updat-
ing completes, disconnect the USB cable.
9 After you disconnect the USB cable, the message
above disappears. Click the
Exit
button to complete
the update.
Reconnect the USB cable to start the unit with the
new firmware.