Tascam US-322 Quick Start Manual - Connecting Other Equipment
4
TASCAM US-322/366
6. When the screen below appears, use the supplied USB
cable to connect the unit to the PC.
Computer
USB
7. When the screen below appears, the installation is
complete. Click the “Reboot now” button to restart the PC
to use the driver.
Installing the driver for Mac OS X
Disconnect the USB cable from the unit before starting instal-
lation.
1. Load the included driver CD-ROM into the computer you
are using.
2. Double-click the CD icon that appears.
3. Double-click the driver disk image file (TASCAM_US-
322_US-366_driver_1.00.dmg), and then double-click the
“TASCAM US-322 US-366 1.00” file inside the open folder.
4. After the installer launches, follow the instructions on the
screen to proceed with the installation.
Restart the computer to complete installation of the
driver.
Connecting other equipment
Front Panel
Guitar
Bass Guitar
Microphone
Headphone
Connect mics to the XLR jacks and guitars to the INPUT 1/L
jack.
CAUTION
•
Before turning a
48V
switch
ON
or
OFF
, turn the output
volume down using the
PHONES
and
LINE OUT
knobs on
the front panel. Depending on the mic, loud noises might
be produced and damage could be caused to equipment
or to people’s hearing.
•
Do not connect or disconnect a mic with an input when its
48V
switch is
ON
.
•
Turn
48V
switch
ON
only when connecting a condenser
microphone that requires phantom power.
•
Do not supply phantom power to an unbalanced dynamic
microphone.
•
Some ribbon mics can be damaged by phantom power. If
unsure, do not supply phantom power to a ribbon mic.
•
Before connecting headphones, minimize the volume
with the
PHONES
knob. Failure to do so could result in
sudden loud noises that might damage your hearing or
cause other harm.
NOTE
On this unit,
INPUT 1/L
and
INPUT 2/R
each have two
input connectors (XLR and TRS). Do not connect signals to
both of these analog input jacks at the same time. If both