Tayana TAYANA-48 Owner's Manual - page 54

ready to put out a fender at the right place. When bringing in the 

anchor chain, back off or swing the boat round so as not to rub 

the chain against the hull. Hold the anchor well clear as you 

bring it aboard so that it does not scrape the stem: lay it on deck 

and lash it down at once, if only temporarily. Never use dirty 

fenders. 

2.3 Fiberglass/Gel Coat Stains & Scratches 

Gel coat and painted surface are very resistance to deep 

stains. Common surface stains can be removed with diluted 

household detergents, providing these detergents do not contain 

ammonia or chlorine. Porcelain-cleaning powders are too 

abrasive and often contain chlorine and ammonia, either of 

which would permanently discolor the Gel Coat and paint. 

Alcohol or kerosene can be used for difficult stains but should be 

washed away promptly with a mild detergent and water. Never 

use acetone or ketone solvents. 

Minor scratches and deeper stains without penetrating the 

Gel Coat may be removed by light sanding and buffing. 

2.4 Fiberglass/Gel Coat Special Care For 

Boats That Are Moored 

If permanently moored in salt water or fresh water, your 

boat will collect marine growth on its bottom. This will detract 

from the boat’s beauty and greatly affect its performance. There 

are two methods of preventing this: 

1.  Periodically haul the boat out of the water and scrub the 

bottom with a bristle brush and a solution of soap and 

water. 

2.  Paint the hull below the waterline with a good grade of 

antifouling paint. DO NOT paint the engine drive 

surface. 

53