Tayana TAYANA-48 Owner's Manual - Pure Natural Cotton Cloth.

condition. And check the lock nuts and pins. 

（4） Check the condition of all underwater fittings 

2.22 Care & Clean of Acrylic Parts 

Acrylics are soft and their surface can be scratched easily by 

improperly cleaning. The scrubbing tools for FRP surface should 

never be used to clean these parts. 

When installing or reinstalling acrylic parts that are fastened with 

screws, do not use a power screwdriver to run the screws all the 

way down. Make the last few turns by hand to avoid over 

lightening and stress cracking the part. 

To Clean Acrylic 

（1） Use a mild soap and plenty of warm water with a soft, all 

cotton cloth and apply only light pressure 

（2） Rinse with clear water and dry by blotting with a damp 

cloth 

（3） Kerosene may be used to remove some grease or paint 

！ 

WHEN CLEANING ACRYLIC PARTS, DO NOT USE 

SOLVENT SUCH AS LACQUER THINNER, ACETONE 

AND DO NOT USE ABRASIVE CLEANERS. 

USE MILD DETERGENT WITH WARM WATER AND 

PURE NATURAL COTTON CLOTH. 

TO REMOVE FINE SCRATCHES YOU MAY USE 

MEGUIARS MIRROR GLAZE #17 BRAND OF 

POLISHING COMPOUND. 

AVOID HIGH TEMPERATURE WHEN POLISHING 

68