Taylor 328 Operating Instructions Manual - page 16
12
Model 328
Important: To the Operator
Power Switch
The center position of the power switch is OFF. The
right position is AUTO, which activates the beater
motor and the refrigeration system. The left position
is WASH, which activates the beater motor only.
Display Light Switch
The display light switch is located under the control
channel. The left position is OFF. The right position
is ON and activates the display light.
Viscosity Adjustment
The viscosity adjustment screw is located on the
right side of the unit under the display light. The
viscosity (thickness) of the product is adjusted by
turning the viscosity adjustment screw clockwise for
a thicker product or counterclockwise for a thinner
product. After making an adjustment, allow the
refrigeration system to cycle 2 or 3 times to
accurately evaluate the viscosity.
Fill Switch
The fill switch is located on the front of the unit, on
the upper left side. The ON position enables the fill
module to replenish and maintain product levels in
the freezing cylinder and the hopper. The OFF
position terminates the fill function.
Indicator Light - WATER OUT
The WATER OUT indicator light is located on the
front of the machine. The light illuminates to indicate
low water pressure. When the required water supply
pressure is re-established, the light extinguishes.
Indicator Light - SYRUP OUT
The SYRUP OUT indicator light is located on the
front of the machine. The light illuminates to indicate
that the syrup has depleted. When the syrup is
replenished, the light extinguishes.
Indicator Light - MIX OUT
The MIX OUT indicating light is located on the front
of the machine. When the light is flashing, it
indicates that the hopper is empty and the mix
supply needs replenishing. To prevent damage to
the unit, refrigeration discontinues automatically
when the MIX OUT indicator light is flashing.
Standby Switch (Toggle Switch)
The standby switch determines which mode of
operation the freezing cylinder is operating in. The
left position places the unit in the AUTO mode. The
right position places the unit in the STANDBY mode.
Note: The power switch must be in the AUTO
position in order for the standby switch to function.
Reset Mechanism
Should an overload condition occur, the freezer will
automatically shut down. To properly reset the
freezer, place the toggle switch in the OFF position.
Wait two or three minutes and then press the reset
button located in the left side panel. Place the toggle
switch in the WASH position and observe the
freezer's performance. Return the toggle switch to
the AUTO position.
Do not use metal objects to press the
reset button. Failure to follow this instruction may
result in electrocution.
Figure 5