Taylor 328 Operating Instructions Manual - page 6
2
Model 328
To the Installer
Air Cooled Units
DO NOT obstruct air intake and discharge
openings:
Air cooled units require a minimum of 3” (76 mm) of
clearance on both sides of the freezer. It is
recommended to place the rear of the unit against
the wall to prevent the recirculation of warm air.
Minimum air clearances must be met to assure
adequate air flow for optimum performance. Failure
to allow adequate clearance can reduce the
refrigeration capacity of the freezer and possibly
cause permanent damage to the compressor.
Electrical Connections
In the United States, this equipment is intended to
be installed in accordance with the National
Electrical Code (NEC), ANSI/NFPA 70-1987. The
purpose of the NEC code is the practical
safeguarding of persons and property from hazards
arising from the use of electricity. This code contains
provisions considered necessary for safety. In all
other areas of the world, equipment should be
installed in accordance with the existing local codes.
Please contact your local authorities.
FOLLOW YOUR LOCAL ELECTRICAL CODES!
CAUTION: THIS EQUIPMENT MUST BE
PROPERLY GROUNDED! FAILURE TO DO SO
CAN RESULT IN SEVERE PERSONAL INJURY
FROM ELECTRICAL SHOCK!
This unit is provided with an equipotential
grounding lug that is to be properly attached to the
rear of the frame by the authorized installer. The
installation location is marked by the equipotential
bonding symbol (5021 of IEC 60417-1) on both the
removable panel and the equipment's frame.
S
Stationary appliances which are not
equipped with a power cord and a plug or
another device to disconnect the appliance
from the power source must have an all-pole
disconnecting device with a contact gap of
at least 3mm installed in the external
installation.
S
Appliances that are permanently connected
to fixed wiring and for which leakage
currents may exceed 10 mA, particularly
when disconnected, not used for long
periods, or during initial installation, shall
have protective devices such as a GFI to
protect against the leakage of current,
installed by authorized personnel to the local
codes.
S
Supply cords used with this unit shall be
oil-resistant, sheathed flexible cable, not
lighter than ordinary polychloroprene or
other equivalent synthetic
elastomer-sheathed cord (Code designation
60245 IEC 57) installed with the proper cord
anchorage to relieve conductors from strain,
including twisting, at the terminals and
protect the insulation of the conductors from
abrasion.
This unit is supplied with a 3-wire cord and
grounding type plug for connection to a single
phase, 60 cycle, branch circuit supply. This unit
must be plugged into a properly grounded
receptacle. The cord and plug provided are 20A for
115/60/1 or 15A for 208-230/60/1. Therefore, the
wall outlet must also be 20A for 115/60/1 or 15A for
208-230/60/1. Check the data label located on the
side panel for electrical specifications.