TC Electronic Classic 450 User Manual - Operation – Rear Panel

9

EN

1 – MAINS IN – Power In & POWER Switch

The Classic450’s auto-sensing switch-mode power-supply

accepts any mains voltage from 90 to 240 volts – you do not

have to change settings, fuses or anything else. Simply connect

a standard IEC three pin connector to the local mains voltage,

and you are up and running. This is particularly handy when you

use the Classic450 on a tour.

The ground pin of the power-supply unit (PSU) must be

connected in order to avoid voltage differences between

e.g. the PA and the Classic450.

2 – SPEAKER OUT

Use the SPEAKER OUT combo connector for connecting the

Classic450 to your cabinet(s). You can use a speaker cable with

either Speakon or ¼" jacks. Do NOT use instrument cables!

The Classic450 can be used to drive any cabinet combination of

up to three RS 210/212/410 cabinets or up to two 8 Ohm

cabinets of another brand. RS cabinets have Speakon inputs.

OPERATION – REAR PANEL

Rear Panel