TC Electronic Classic 450 User Manual - Quick Setup Guide
If you just can’t wait…
Here are a few quick steps to get you playing within minutes.
Unpacking
•
Unpack your Classic450 amp.
•
The box should contain the following items:
–
Classic450 amplifier
–
Power Cable
–
Manual
•
Inspect all items for signs of transit damage. In the unlikely
event of any damage, inform the carrier and supplier.
•
In case of damage, keep all the packaging, as this will show
evidence of excessive handling force.
•
It is also a good idea to keep the packaging for future
transportation.
Setting up
•
Connect the Speaker Out jack of the amplifier to your
cabinet using a Speakon speaker cable. RS cabinets come
with a speaker cable included, so if you have bought a RS
cabinet, you are all set to go.
•
You can connect up to three RS cabinets or any other two 8
Ohm cabinets of another brand to the amplifier. The
minimum load is 4 Ohm.
•
Connect the power cable and power up. The Classic450’s
power supply accepts voltages from 100 to 240 VAC.
•
Connect your bass to the input jack on the front panel.
•
Adjust the input gain using the GAIN knob.
•
Adjust the output volume using the MASTER knob.
•
Play!
Accessories
The following items can be purchased from your music dealer:
•
RS cabinets 210/212/410
•
19" bracket (allowing you to mount the amplifier in a
standard 19" rack)
•
Classic450 soft bag
•
Classic450 flight case
•
Flight cases for RS cabinets.
Be sure to check www.tcelectronic.com for latest news about
these and other TC products.
QUICK SETUP GUIDE
5
EN