TC Electronic Classic 450 User Manual - page 3
a
EN
1 Read these instructions.
2 Keep these instructions.
3 Heed all warnings.
4 Follow all instructions.
5 Do not use this apparatus near water.
6 Clean only with dry cloth.
7 Do not block any ventilation openings. Install in accordance with the
manufacturer’s instructions.
8 Do not install near heat sources such as radiators, heat registers, stoves, or other
apparatus (including amplifiers) that produce heat.
9 Do not defeat the safety purpose of the polarized or grounding-type plug. A
polarized plug has two blades with one wider than the other. A grounding type plug
has two blades and a third grounding prong. The wide blade or the third prong are
provided for your safety. If the provided plug does not fit into your outlet, consult an
electrician for replacement of the obsolete outlet.
10 Protect the power cord from being walked on or pinched, particularly at plugs,
convenience receptacles, and the point where they exit from the apparatus.
11 Only use attachments/accessories specified by the manufacturer.
12
12
Use only with the cart, stand, tripod, bracket,
or table specified by the manufacturer or sold with the apparatus. When
a cart is used, be careful when moving the cart/apparatus combination
to avoid injury from tip-over.
13
Unplug this apparatus during lightning storms or when not
in use for longer periods of time.
14 Refer all servicing to qualified service personnel. Servicing is required when the
apparatus has been damaged in any way, such as when a power supply cord or
plug is damaged, liquid has been spilled or objects have fallen into the apparatus,
or if the apparatus has been exposed to rain or moisture, does not operate
normally or has been dropped.
•
This equipment should be installed near the socket outlet and disconnection of the
device should be easily accessible.
•
To completely disconnect from AC mains, disconnect the power supply cord from
the AC receptacle.
•
The mains plug of the power supply shall remain readily operable.
•
Do not install in a confined space.
•
Do not open the unit – risk of electric shock inside!
Caution:
You are cautioned that any change or modifications not expressively approved in this
manual could void your authority to operate this equipment.
Service
•
There are no user-serviceable parts inside.
•
All service must be performed by qualified personnel.
IMPORTANT SAFETY INSTRUCTIONS
Voltage
Line plug according to standard
110-125V
UL817 and CSA C22.2 no 42.
220-230V
CEE 7 page VII, SR section
107-2-D1/IEC 83 page C4.
240V
BS 1363 of 1984.
Specification for 13A fused plugs and switched
and unswitched socket outlets.
Warning!
•
To reduce the risk of fire or electrical shock, do not expose this equipment to
dripping or splashing and ensure that no objects filled with liquids, such as vases,
are placed on it.
•
This apparatus must be earthed.
•
Use a three wire grounding type line cord like the one supplied with the product.
•
Be advised that different operating voltages require the use of different types of line
cord and attachment plugs.
•
Check the voltage in your area and use the correct type. Please refer to the
following table: