TC Electronic INTONATOR User Manual - Setup
12
SETUP
Dither - Page 6
You can dither to 8, 12, 16, 20, 22 or 24 bit.
Note: No truncation takes place in the Intonator. The Intonator
will Output all 24 bits on all digital Outputs. Dither is only
present on digital Outputs.
MIDI Control Change Channel - Page 7
Transmits and receives MIDI for most controls and applied Pitch
Correction Amount. Select MIDI channels 1-16 or Off.
Control and MIDI Pitch channel cannot be the same.
MIDI Pitch Channel - Page 8
Transmits the incoming pitch via Note and Pitch bend messages.
Select MIDI channels 1-16 or Off.
Control and MIDI Pitch channel cannot be the same.
Tuning Reference - Page 9
The Tuning reference has a range of +/-40Hz with center at
440Hz. The manual pitch bend knob can be used to change the
tuning reference. Any of the keyboard keys can be pressed to
Output a tone which you can use as a tune reference to other
sources.
Bend Range - Page 10
Select between different ranges for the front panel MANUAL
PITCH bender. Select range +/- 50 cents or +/- 200 cents.
Routing - Page 11
There are two Routing modes to choose from:
Normal
Pitch and Dynamics on selected Input channel.
Dual
Pitch and Dynamics on separate Input channels.
Since the material you often would like to process with the
Intonator is mono (i.e. single vocals) we found that splitting the
unit in a Pitch Correction section and Dynamics section would be
useful.
This way you are allowed to assign the Pitch Correction section
to one channel and the Automated Dynamics (De-ess and Low Cut)
section to the other.
The Dual mode overrules the Left/Right selections In Setup page 1.
Ana. Out - Page 12
The range is -26dB to 6dB.
A 0dB setting equals full scale @ +16dBu
Digi In Lv - Page 13
The range is -26dB to 0dB
De-ess - Page 14
This is where you set the Cross-over frequency for the De-esser.
The range is 1kHz to 10kHz. Default setting is 4.7kHz.
Ch. Status - Page 15
Both AES and S/PDIF Outputs carry the same status bit
information. Select between AES or S/PDIF.