TC-Helicon VoiceTone Create Product Manual - Tear-Out | Reference

39

Quick Setup

1.

Connect the mic/cable to the Mic Input on Create

2. Connect a mic cable from the Left (mono) Output of

Create to a mic input on your sound system.

3. Set the Input Knob fully left, and the Mix Knob to 12

o'clock.

4. Connect Create's power adapter to main power and to

the Power Input on Create.

5. While singing through your microphone, turn the Input

Knob to the right until the Input Light turns green, sometimes

orange on louder parts, but never red.

6. Turn up your sound system level. You're ready to add

effects to your voice.

Information for Your Sound Engineer

Don’t Worry

It can be a scary night when a singer brings an effects pedal to

a gig and you are expected to get good sound. Don’t worry,

VoiceTone Create has a quality mic pre with 109 dB SNR, and

the patches are authored specifically for voice.

Phantom Power

Create can supply phantom power to a condenser mic - press

and hold Buttons 1 & 2 until the 48V light turns on. Sending

external power to Create will not cause damage, but there will

be a pop when power is removed.

Output Level

The outputs on Create are +1dBu, just like a hot condenser

microphone.You won’t need a DI box.

Output Configurations

If you want to mix wet and dry yourself, take Create out of

stereo mode (hold Buttons 4 and 5 until the Stereo light turns

off) and turn the Mix Knob fully right. In this configuration, the

Left Output is fully wet and the Right Output is fully dry.

Tear-Out | Reference

Tear this page out,

plasticiz

e it and car

ry

 it with y

ou to gigs f

or ref

erence