TDK TVT1001BLK User Manual - page 5
8
9
1. Motor/Motor Cover
2. Drive Belt
3. Spindle
4. Tone Arm Lifter
5. Counter Weight
6. Anti-Skate Control
7. Cue Lever
8. Tone Arm Rest
9. 33/OFF/45 Control with
Power Indicator
10. Platter
11. Tone Arm Light
12. Stylus (Stylus Part No.
069-MG2801-01R*)
13. Display
14. Tone Arm
15. Audio Out Jacks
16. PRE-AMP ON/OFF Switch
(Please see caution on use
of this switch on page 12.)
17. B Type USB Out Jack
(TVT2002 only)
18. Power Jack
*Consumer Replaceable Part
(See page 34 to order.)
LOCATION OF CONTROLS
9
1
10
11 12 13 14
2
3
5 6
4
7 8
15 16 17 18
TOP
REAR
SETUP
After unpacking, set up the unit as follows:
1. Gently place the Platter onto the Spindle,
making certain that the Platter is fully seated
before proceeding to the next step.
2. Place the Platter Cover onto the Platter.
3a. Remove the plastic
cover from the stylus.
3b. Gently pull the Drive Belt around the Motor
Pulley. Be careful to not allow finger grease or
other contamination to foul the belt.
NOTE:
The Drive Belt comes installed around the Platter.
4. Place the Motor Cover onto the Motor,
making sure each side has the Drive Belt
coming through.
Imation Confidential - Use Only By Permission
Controlled material extracted from Matrix on Aug 24, 2010 08:31:11 AM CDT