TDK TVT1001BLK User Manual - page 8
14
15
SETUP (CONTINUED)
OPERATION
1. Put a record on the turntable and remember to use the 45
adapter if using a 45 single record.
NOTE: Some 45 single records may not need the 45 adapter.
2. Rotate the 33/OFF/45 control to the 33 or 45 position
(to match the record being played); the Power indicator
and display will light.
3. Lift the Tone Arm and move over the Platter. The Platter will
start spinning and the Tone Arm light will illuminate.
4. Lower the Cue Lever.
5. Place the Tone Arm on the edge of the record to start at the
beginning or anywhere on the record’s playing surface to start
playback at that point. The display will show the spectrum of the
record’s output.
6. If the sound is distorted, check the tonearm balance,
counterweight and anti-skating setting previously adjusted.
Also check for accumulated dust on the stylus by visual
inspection.
(See page 10 for Installation of the counterweight.)
C. TO USE WITH A UNIT WITH PHONO PREAMPLIFIER INPUTS (RECEIVER, PRE-AMP, ETC.):
(See page 10 for the Warning regarding the PRE-AMP switch.)
6c. Slide the PRE-AMP ON/OFF switch on the rear of the
unit to the OFF position.
7c. Connect the left and right plugs of the Audio Cable
(included) to the Left and Right Out jacks on the rear
of this unit, matching the red to red and white to white.
Connect the other end of the Audio Cable to the Phono
In jacks of the Home Stereo or similar equipment.
8c. Insert the small end of the AC adapter into the Power jack
(located on the rear of the unit). Connect the other end
to a wall outlet having 120V AC, 60 Hz.
NOTES:
• Remove both the DC plug and the AC IN plug to
disconnect the AC adapter when not in use.
• Only use the supplied AC adapter which has the
following specs: DC 12V.
• After connecting, set the external unit to receive the
signal from its Phono Input jacks.
OUTPUT
R
L
R L
R L
Amplifier
Turntable
TO AC
JACK
Imation Confidential - Use Only By Permission
Controlled material extracted from Matrix on Aug 24, 2010 08:31:11 AM CDT