TDK VELO CD REWRITER Installation And User Manual - page 6
This chapter explains how to physically install your veloCD ReWRITER in your computer.
The steps are as follows:
1. Turn OFF your computer system and unplug the power cord.
2. Set the jumpers for your new veloCD ReWRITER.
3. Mount the veloCD ReWRITER into an available drive bay inside the computer system.
4. Make all necessary cabling connections: IDE cable, power cable, and audio cable.
5. Turn your computer system ON.
The following pages give more details for this procedure.
TO OPEN THE COMPUTER:
1. Before proceeding, make sure the power to your computer and any external peripherals are OFF
and your computer is UNPLUGGED from its power source.
2. Remove your computer’s cover, following the directions provided by your computer’s manufacturer.
Typically, this involves loosening or removing several screws on the back panel of your computer
and sliding off the cover. See Figure 3 for details.
Figure 3: Removing a Typical Computer's Cover
SECTION 2 : Installing Your veloCD ReWRITER
5
Figure 2: Rear Panel of the veloCD ReWRITER Internal Drive
•
Audio output connector: Outputs stereo analog signal. Use to connect to soundcard or audio amplifier.
Use standard MPC-3 type, 4-pin connector.
•
Jumpers: Use to select operation as an IDE master or slave, or for cable select. In general, leave
these jumpers at their factory settings.
•
IDE cable connector: Connects to IDE interface using 40-pin IDE flat ribbon cable.
•
Power connector: Connects to your computer’s power supply to provide
DC +5V and +12V to the veloCD ReWRITER.
4
veloCD ReWRITER : User’s Manual
SECTION
2
INSTALLING YOUR veloCD ReWRITER
Audio
CSEL
E-IDE Interface
Power
Slave
Master
39
40
1
2
Digital
D G
R G G L
5V G G 12V
Analog
Power
connector
IDE cable
connector
Jumper
(not used)
Audio output
connector
AUDIO OUT
R G L
CABLE SELECT
SLAVE
MASTER
Jumpers
40
IDE
DC INPUT
1
+5V GND +12V
KD.tdk.03202 40xHardware V12 10/16/02 04:52 PM Page 4