TDK Velocd Quick Manual - page 5
Manual is about: Internal ATAPI-IDE CD ReWRITER Drive
of
12
5. Connect the other end of the USB cable to the back of your veloCD drive.
6. Connect the power cord to the back of your veloCD drive.
7. Connect the plug to a wall outlet or power strip.
8. Power on your veloCD drive using the switch in the back of the drive.
9. If your computer is on, a "New Hardware" window should appear. If a previously installed Hi-
Speed USB driver has already been recognized, follow the on-screen prompts. If the driver needs
to be installed, follow the instructions in the Troubleshooting section following this page.
10. Open the CD tray by pressing the EJECT button on the front of your veloCD drive.
8
10