TDK Velocd Manual

Manual is about: Internal ATAPI-IDE CD ReWRITER Drive

Summary of Velocd

  • Page 1

    High speed usb 2.0 external cd-rewritable drive for pc v1 tdk.L25.03/52x usb velocd 3/5/03 2:17 pm page 1.

  • Page 2

    Fcc notice this equipment has been tested and found to comply with the limits for a class b digital device, pursuant to part 15 of the fcc rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and...

  • Page 3: Supplied With:

    High-speed usb 2.0 external cd-rw drive supplied with: velocd drive usb 2.0 cable (a-b) pc software ac/dc adapter drive stand emergency ejector pin manual quickstart guide minimum system requirements: windows: pentium iii 333 mhz or higher windows 98se/me/2000/xp 64 mb ram • notes: when connected to...

  • Page 4: Plug And

    1.Insert the program installation cd into your computer’s original disc drive. 2.Install the tdk cd blender software suite by clicking on the desired programs. Follow the on-screen prompts to finish installation. 3.Locate the usb 2.0 port on your pc. 4.Connect the flat end of the usb cable to the pc...

  • Page 5: Installing The

    To install the high speed usb driver: 1. Insert the tdk cd blender software suite disc into your existing cd-rom drive. 2. Connect the included usb 2.0 cable to your external drive and to a usb 2.0 port on your pc, then power the drive on. • the “add new hardware wizard” dialog box will appear. 3. C...

  • Page 6: Troubleshooting

    Troubleshooting verify that the drive is connected to a usb 2.0 port. If the drive is connected to a usb 1.1 port, recording will be limited to 4x maximum speed. Ensure that dma is enabled (windows 98se/me) 1. In windows, click the start button, then settings, then control panel. 2. Double click sys...

  • Page 7: Troubleshooting

    Troubleshooting (continued) can’t create a cd using cd-r or cd-rw media. Can’t hear an audio cd through the velocd headphone jack. Can’t read a session after a successful write. Can’t eject the cd. The drive does not power up. The computer does not start up. 1. A buffer underrun occurred. Either sel...

  • Page 8: Troubleshooting

    1. Make sure the usb cable is fully connected at both ends. 2. Verify that the drive is properly connected to the computer using a working usb cable. 3. Make sure the usb driver included in the bonus utilities folder on the cd blender recording software suite program disc is installed. (see the sect...

  • Page 9: Tdk Limited Warranty

    Tdk limited warranty one year limited warranty for hardware tdk electronics corporation ("tdk") warrants to the end-user customer that this data storage product, exclusive of software (referred to here- in as "hardware" or "product") will be free from defects in material and workmanship for a period...

  • Page 10

    1 3 4 2 front panel (see illustration) 1) headphone jack: stereo mini-jack 2) thumbwheel volume control 3) tray open/close button 4) emergency eject hole tdk.L25.03/52x usb velocd 3/5/03 2:17 pm page 11.

  • Page 11

    Tdk.L25.03/52x usb velocd 3/5/03 2:17 pm page 12.