TDK Velocd Manual - Plug And
1.Insert the program installation CD into your computer’s original disc
drive.
2.Install the TDK CD Blender Software Suite by clicking on the desired
programs. Follow the on-screen prompts to finish installation.
3.Locate the USB 2.0 port on your PC.
4.Connect the flat end of the USB cable to the PC’s USB 2.O port.
PLUG AND
PLAY
5. Connect the other end of the USB cable to the back of your veloCD drive.
6. Connect the power cord to the back of your veloCD drive.
7. Connect the plug to a wall outlet or power strip.
8. Power on your veloCD drive using the switch on the back of the drive.
9. If your computer is on, a "New Hardware" window should appear. If a previously installed Hi-
Speed USB driver has already been recognized, follow the on-screen prompts. If the driver needs
to be installed, follow the instructions in the “INSTALLING THE HIGH SPEED DRIVER” section
following this page.
10. After installation, open the CD tray by pressing the EJECT button on the front of your drive.
EASY TO SET-UP AND USE
8
3
4
5
6
7
10
TDK.l25.03/52x USB veloCD 3/5/03 2:03 PM Page 4