Teac CD-H750 Owner's Manual - page 24
24
Display (2)
Before recording
You can convert audio on a CD into MP3 format files and record them
on a USB flash drive.
When using an MP3/WMA disc, the ID3 tags will also be copied to the
USB flash drive.
CAUTION
Do not disconnect the power cord during recording.
It may cause damage to the products.
before recording. If not, the recording quality will be poor.
Note
such as “Audio001.MP3”, “Audio002.MP3”, …….
For Example:
If there are “Audio004.MP3” and “Audio009.MP3” files in the AUDIO
folder, and you make a recording, the new file will be “Audio010.
MP3”.
drive using your PC.
You cannot check the remaining capacity with this unit.
If more than 2000 files are stored on the USB flash drive, CD-H750
can not play correctly, and cannot record any files.
at a bit rate of 64 kbps, 96 kbps, 128 kbps or 192 kbps.
iPod
Changing the display mode
You can select the iPod/iPhone screen or CD-H750 display to show
the menu.
When an iPod/iPhone is connected, hold down the MENU button for
more than 4 seconds to select which display is used.
Direct Mode (default)
You can control the iPod/iPhone using the menu on the screen of the
iPod/iPhone.
The display of CD-H750 constantly shows “Direct Mode”.
Extended mode
You can control the iPod/iPhone using only CD-H750.
Information of the songs is displayed on the display of CD-H750.
characters (such as Japanese, Chinese, etc.) correctly. title/Album/
Artist names of songs should be in alphanumeric characters.
the USB cable connecting the unit to the iPod/iPhone is
disconnected.