Teac CD-W512S Requirements And Notices - Configuring The Cd-Rw Drive
Setting the SCSI ID Number
TEAC CD-RW Installation Guide
4
Configuring the CD-RW Drive
Before you can install and operate the TEAC CD-W512S CD-RW drive, you need to
do the following:
❑
Install a SCSI adapter card in the host computer. For optimum performance, a
PCI bus master SCSI adapter card (such as an Adaptec 2940 or equivalent) is
recommended. Please refer to the SCSI adapter card documentation for
installation instructions.
❑
Set the SCSI ID number on the rear panel of the CD-RW drive
❑
Terminate the CD-RW drive if it is located at the end of the SCSI chain.
Setting the SCSI ID Number
To set the SCSI ID number on the CD-RW drive, you must set jumpers on the rear
panel of the unit.
You set the SCSI ID number for the CD-RW drive by placing jumpers in various
combinations on jumper pin pairs S0, S1, and S2. (“S” indicates a jumper pin pair
number.) The following table indicates the appropriate pin combinations. “Close”
indicates that you should place a jumper on the specified jumper pins. “Open”
indicates that you should not place a jumper on the specified pins (leaving the
connection “open”). For example, to set the CD-Recorder to SCSI ID 5, you would
place jumpers on jumper pin pairs S0 and S2.
The factory default setting is SCSI ID 3 (S0 and S1 closed).
SCSI
ID
0
1
2
0
Open
Open
Open
1
Close
Open
Open
2
Open
Close
Open
3
Close
Close
Open
4
Open
Open
Close
5
Close
Open
Close
6
Open
Close
Close
7
Close
Close
Close
jumper
jumper pins
jumper pin configuration block
SCSI ID
Parity Switch
Termination
“S” numbers
Factory
use only.
CD-W512Sshort.fm Page 4 Thursday, December 14, 2000 10:30 AM