Teac CD-W512S Requirements And Notices - page 7
Installing the CD-RW Drive
TEAC CD-RW Installation Guide
7
7.
Connect the power cable to the power connector on the rear panel of the
CD-RW drive.
Insert the power cable plug in the correct orientation into the power connector.
The plug is shaped so that it can be easily inserted in only one orientation; do
not force the plug into the connector.
The +5v terminal is on the left as you face the rear of the panel; the +12v
terminal is on the right. The two center terminals are ground terminals.
8.
Re-install your computer’s cover, faceplate, or bay cover.
9.
Start your system.
Notes:
❑
The TEAC CD-RW drive is a true Plug-N-Play device; therefore, it will
be detected automatically by Windows 95/98/Me/2000-Professional.
There is no need to install any drivers.
❑
Windows NT 4.0 does not support the Plug-N-Play feature. Therefore,
confirm that the proper drivers are installed for your SCSI adapter card.
If not, open the Control Panel, double click “SCSI Adapters,” click the
“Drivers” tab, then click the “Add” button. At the “Select a SCSI
Adapter Option” window, select the drivers for your SCSI adapter card.
Click “Install” and follow the instructions on screen.
❑
The drive is recognized by the operating system as a typical CD-ROM
drive. Once you confirm that you can read (play) data discs from the CD-
RW drive, install your pre-mastering or recording software to enable
recording to CD-R and CD-RW discs. Refer to “Recommended Soft-
ware” on page 8.
CD-W512Sshort.fm Page 7 Thursday, December 14, 2000 10:30 AM