Teac SR-L200i Owner's Manual - page 3
www.flash-butrym.pl
Page 3
●
Fixing instruction
This product can Works outdoor Or indoor. air temperature must be under 35*C.
Please read this user’s manual carefully before fixing, operation or maintain.
Please confirm if the product has been shatted during shipment.
Please confirm that the power supply is disconnected and the lamp is cool before you
change lamp.
The side has bleb is up, do not touch the lamp with key and digital display.
Put the light at breezy and confirm fans is ok.
Put the yellow/ green 2 color wire on the ground.
2500W garnet curtain use 20A/ 500V fuse.
●
Operation
2500W garnet curtain control and design the tunnel with key and digital display.
It adopts DMX512 single or main – follower control model is ok, you can control several
light by design tunnel.
Connecting output of controller with input of no 1 light, then contact the output of no 1 light
with input of no 2 light. The rest maybe deduced by analogy as the following photo.
Warning
2500W garnet curtain light use 3 core XLR plug, please change 5 core to be 3 core if your
controller use 5 core plug please note the follow photo.
It takes about 20 minutes for the lamp to cool, and the you re-start it again.
The light will inspect itself when it begin to work, it can be operated after finish inspecting.
Please do not use this product tingle.