Triple S 20C Operating Instructions Manual - page 8
1
8
MACHINE PREPARATION
5. CONNECTING THE BATTERY CONNECTOR
After charging the batteries, reconnect the battery connector (2) to the connector of
the machine (1).
6. BATTERY CHARGE LEVEL INDICATOR
The batteries’ indicator is digital with 4 fixed positions and a blinking one. The
numbers, which appear on the display, show the approximate charge level.
4
= maximum charge,
3
= charge 3/4,
2
= charge 2/4,
1
= charge 1/4,
0
= (blinking) discharged batteries)
7. SQUEEGEE ASSEMBLY
The squeegee is assembled as shown in the figure. The squeegee lever should be in
its up position. Insert the holding pin into the squeegee stud bolt to secure the
squeegee in place. Then fit the squeegee hose into its coupling; the hose should be
located to the right of the lifting cable.
8. ADJUSTING THE SQUEEGEE HEIGHT
The height from the floor to the squeegee should be adjusted based on the blade’s wear.
Rotate the wing nuts (1) counter-clockwise to lift the squeegee and clockwise to lower
it.
Note:
Adjust the right and left wing nuts the same amount; the squeegee should be
positioned parallel to the floor.
NOTE:
The brush motor automatically switches off a few seconds after the battery
indicator light begins to blink. By restarting the machine, you will be allowed to turn
on the vacuum motor and finish drying any wet areas.