Overlay door panel installation instructions for wine captain models 2075wcol and 2015wcol u-line corporation p.O. Box 245040 • milwaukee, wi 53224-9540 phone 414.354.0300 • fax 414.354.7905 www.U-lineservice.Com printed in u.S.A. P/n 30009 (rev. 3/03).
2 part number description quantity 12041 insert 8 mm plug 2 20002 screw #6 x 1 pan head 10 42122 screw #6 x 1/2 large flat head 2 35003 foam tape - .093 x .375 x 8' 1 overlay panel kit parts supplied.
3 prepare the new overlay panel refer to the overlay panel preparation instruction sheet, part number 30010. Figure 1 – remove existing door from the cabinet a. Remove top hinge screw pin (7/64" hex key). Remove the door by tilting forward and lifting off the bottom hinge pin. B. Lay door on a clean...
4 b. Visually check for gap between panel and glass. If there is an objectionable gap, continue to figure 3 – applying foam tape to overlay. C. If there is little or no gap between panel and glass, continue to figure 4 – attaching the overlay panel. Figure 3 – applying foam tape to overlay (if requi...
5 figure 4 – attaching the overlay panel a. Tap nylon inserts into the two holes drilled in the wood panel. Use two #6 screws (p/n 42122) to attach top pivot bracket (p/n 12029) to the wood door panel (figure 4). Figure 4 b. If required, attach optional cabinet handle hardware to the wood door panel...
6 figures 5-6 – attaching the overlay to the door figure 5 a. Secure existing door with the front of the door to the back of the overlay using tape, on all four corners as shown (figure 5). Make sure all four edges are aligned. Figure 6 (model 2075 shown) #6x1" pan-head screw (10 total) tape door fr...
B. Place door and overlay on a clean flat protective surface. Use the door frame holes as a guide to lightly punch pilot holes for the #6 x 1" pan-head screws (see figure 6). C. Attach the door to the overlay using the #6 x 1" wood screws. (model 2075 shown.) note: the door frame is designed with a ...
A. Remove the door closers from the bottom hinge, clean thoroughly and apply petroleum jelly to the mating surfaces of the closers (figure 8). Be sure that bosses on closers align with holes in hinge and hinge plate. B. Position door and install the pivot post (p/n 42096) into the top hinge (using t...
1. Use the following instructions to create or have a wood overlay panel created for your Échelon wine captain model as shown in figure 1. Figure 1 – wood panel dimensions note rear view of wood panel with right hand hinge shown (mirror image for left hand hinges.) pivot plate relief figure 2 b a a ...
Figure 2 – pivot plate relief, hinge holes and routing 2. Create pivot plate relief as shown in figure 2. 3. Drill holes for pivot plate mounts, upper door hinge and lower door hinge as shown. 4. The overlay door panel must be installed in accordance with the installation instructions, part number 3...
