Full overlay door panel installation instructions for models 2075, 2015 and clr 2060 u-line corporation p.O. Box 245040 • milwaukee, wi 53224-9540 phone 414.354.0300 • fax 414.354.7905 printed in u.S.A. P/n 30-10011.
Part number description quantity 12041 insert 8mm plug 2 42120 spacer nylon 3/8 od x .19 id 8 42121 screw #10 x 5/8 round head 8 42122 screw #6 x 1/2 large flat head 2 11901-2* pivot plate wood 1 12020* wood panel bottom hinge 1 12021* wood panel top hinge 1 12029* top pivot bracket 1 31672 door clo...
1. Remove existing door from the cabinet a. Remove top hinge screw pin (7/64" hex key). Remove the door by tilting forward and lifting off the bottom hinge pin. B. Pull door gasket out of the groove (top edge of door only). Start in the middle and pull outward, moving toward the edge (see figure 1)....
3. Attaching the full overlay panel a. Tap nylon inserts into the top holes drilled in the wood panel. Use two #6 screws (p/n 42122) to attach top pivot bracket (p/n 12029) to the wood door panel (see figure 3). B. If required, attach optional cabinet handle hardware to the wood door panel at this t...
14-5/16" ± 1/4" drill 5/32" x 3/8" deep 7 places - model 2075 6 places - model 2015 and clr 2060 for use with #10 x 5/8" wood screw and nylon spacer for use on model 2075 only. 27" ± 1/4" 1" ± 1/32" 1" ± 1/8" 11-7/8" 1" ± 1/32" figure 5 for models 2015 and clr 2060, omit the center hole..
D. Attach the door panel to the wood panel using #10 x 5/8’’ (p/n 42121) wood screws and nylon spacers (p/n 42120). The nylon spacers fit between the wood panel and the door panel as shown (see figure 6). E. Remove the existing bottom pivot plate and replace with the overlay panel pivot plate (p/n11...
4. Assembling the door and wood panel a. Install the overlay panel by sliding the door panel back into the door frame. B. Replace the two-piece modified handle assembly and secure with the two screws removed in step 1 e. C. Starting at the corners and working toward the center, push the door gasket ...
C. Install the pivot post (p/n 42096) into the bottom hinge (using the 7/64’’ hex key) and install the hinge onto the cabinet. D. Replace the door closure assembly onto the bottom pivot post (see figure 9). Be sure that bosses on closures align with holes in hinge and hinge plate. E. Place the modif...
1. Cut door panel to proper size (figure 1). Be sure to note which model the door will be used on. Figure 1 rear view of wood panel for right hand hinge shown. Use mirror image for left hand hinges. 2. Create a relief (figure 2) for pivot plate by cutting notch in top corner and coinciding back corn...
U-line corporation p.O. Box 245040 • milwaukee, wi 53224-9540 phone 414.354.0300 • fax 414.354.7905 www.U-line.Com figure 3a top view of door figure 3b back view of door figure 3c bottom view of door figure 3d side view of door 3/4" 1/8" 1/8" r1/32" door bottom: chamfer 1/32" x 45 ° 5/16" dia. X 1/4...
