1. DL manuals
  2. U-Line
  3. Refrigerator
  4. CLR2060
  5. Installation Manual

U-Line CLR2060 Installation Manual

Summary of CLR2060

  • Page 1

    Www.U-lineservice.Com phone (414) 354-0300 • fax (414) 354-7905 service & parts tech lines phone (800) 779-2547 • fax (414) 354-5696 onlineservice@u-line.Com ©2005 u-line corporation 02/2005 clr2060 — clear ice maker installation guide ™.

  • Page 2

    Clr2060 — clear ice maker www.U-lineservice.Com 2 02/2005 ™ contents cut-out dimensions . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 product dimensions . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 door swing/clearances information . . . . . . . . . . . . . . 4 reversing the d...

  • Page 3

    Clr2060 — clear ice maker 02/2005 3 www.U-lineservice.Com ™ general precautions use this appliance for its intended purpose only and follow these general precautions along with those listed throughout this guide: warning shock hazard — electrical grounding required. • keep the unit unplugged through...

  • Page 4

    Clr2060 — clear ice maker www.U-lineservice.Com 4 02/2005 ™ your u-line product has been designed for either free- standing or built-in installation. When built-in, your unit does not require additional air space for top, sides or rear. However, the front grille must not be obstructed and clearance ...

  • Page 5

    Clr2060 — clear ice maker 02/2005 5 www.U-lineservice.Com ™ reversing the door (black and white units only) all u-line units (except stainless steel models) may be left- or right-hand opening. The door opening is easily reversed by moving the hinge hardware to the opposite side. The top hinge hardwa...

  • Page 6

    Clr2060 — clear ice maker www.U-lineservice.Com 6 02/2005 ™ other site requirements power supply the unit requires a grounded and polarized 115 vac, 60 hz, 15a circuit (normal household current). See electrical specifications on page 16. Water supply the unit requires a 1/4-inch od water supply line...

  • Page 7

    Clr2060 — clear ice maker 02/2005 7 www.U-lineservice.Com ™ (black and white units only) two types of custom door panels can be installed on your black or white unit to harmonize with or accent the surrounding décor: a custom 1/4" insert or a full overlay. If no custom door panel is used, go on to 5...

  • Page 8

    Clr2060 — clear ice maker www.U-lineservice.Com 8 02/2005 ™ full overlay door panel door panel preparation a full overlay door panel completely covers the doorframe and handle to give a built-in appearance. See your u-line dealer for the optional full overlay door panel kit (p/n u-ol2015b — black or...

  • Page 9

    Clr2060 — clear ice maker 02/2005 9 www.U-lineservice.Com ™ 4. Drill hole for upper door hinge (top of panel) (see figure 16, top view). 0.177" diameter (#16 drill) x 11/16" deep 5. Drill hole for lower door hinge (see figure 16, bottom view). 5/16" diameter x 1/4" deep caution it is important to en...

  • Page 10

    Clr2060 — clear ice maker www.U-lineservice.Com 10 02/2005 ™ 4. Attach the door panel to the overlay panel using #10 x 5/8" wood screws and nylon spacers. The nylon spacers fit between the overlay panel and the door panel as shown in figure 22. The spacers allow the original door panel to slide back...

  • Page 11

    Clr2060 — clear ice maker 02/2005 11 www.U-lineservice.Com ™ 3. Install the pivot post into the new replacement bottom hinge (using the 7/64" hex key or phillips screwdriver) and install the hinge onto the unit. 4. Replace the door closure assembly onto the bottom pivot post (see figure 25). Be sure...

  • Page 12

    Clr2060 — clear ice maker www.U-lineservice.Com 12 02/2005 ™ 3. See figure 28. If the top far edge of the door needs to move up, move the hinge plate toward the outside of the door and retighten screws. If the top far edge of the door needs to move down, move the hinge plate toward the inside of the...

  • Page 13

    Clr2060 — clear ice maker 02/2005 13 www.U-lineservice.Com ™ if using a gravity drain: 1. Attach the 5/8-inch id drain connection on the back of the unit to a 5/8-inch od rigid tube, using a worm clamp. 2. Attach the other end of the rigid tube to your 5/8-inch id drain line with a worm clamp. 3. In...

  • Page 14

    Clr2060 — clear ice maker www.U-lineservice.Com 14 02/2005 ™ to check and test hose connections: 1. Make certain the unit is not plugged into an electrical outlet. 2. Carefully push the power cord grommet through the hole in the back panel (see figure 35). 3. Remove 12 screws and back panel. Warning...

  • Page 15

    Clr2060 — clear ice maker 02/2005 15 www.U-lineservice.Com ™ caution in the event of a power outage, restricted drain or pump failure, the failure to use the u-line p60 drain pump or a pump with the above listed specifications, could result in substantial water leakage and pooling with severe and co...

  • Page 16

    Clr2060 — clear ice maker www.U-lineservice.Com 16 02/2005 ™ electrical specifications caution electrical installation must observe all state and local codes. This unit requires connection to a grounded (three- prong), polarized receptacle that has been placed by a qualified electrician. The unit re...

  • Page 17

    Clr2060 — clear ice maker 02/2005 17 www.U-lineservice.Com ™ 2. If the ice maker is not level, adjust the feet on the corners of the unit as necessary (see figure 44). 3. Check the levelness after each adjustment and repeat the previous steps until the unit is level. Go on to 9 install the unit. Ins...

  • Page 18

    Clr2060 — clear ice maker www.U-lineservice.Com 18 02/2005 ™ installation troubleshooting problem q: water is leaking under the unit. Solution a: a water leak under the unit is most likely caused by a bad connection in the water supply line. Make sure the water line’s brass fitting is screwed tight ...

  • Page 19

    Clr2060 — clear ice maker 02/2005 19 www.U-lineservice.Com ™ 4. Watch the water flow over the evaporator assembly (ice cube tray) to familiarize yourself with the operation. Upon initial start-up, water flow over the evaporator may be uneven. This may cause uneven sized cubes or water spilling into ...

  • Page 20

    ™ ©2005 u-line corporation publication no. 30051e 02/2005 u-line corporation, located in milwaukee, wi, is a family operated manufacturer of built-in undercounter icemakers, combo ® icemaker/refrigerators, wine captain ® wine storage units, refrigerators, refrigerated drawers and refrigerator/freeze...