1. DL manuals
  2. U-Line
  3. Refrigerator
  4. CLR2060
  5. Supplementary Manual

U-Line CLR2060 Supplementary Manual

Summary of CLR2060

  • Page 1

    Www.U-lineservice.Com phone (414) 354-0300 • fax (414) 354-7905 service & parts tech lines phone (800) 779-2547 • fax (414) 354-5696 onlineservice@u-line.Com ©2006 u-line corporation 04/2006 publication no. 30163 full overlay door panel to convert 2075, 2015 and clr2060 panels for use on the new 217...

  • Page 2

    Www.U-lineservice.Com 2 04/2006 installation instructions removing existing door 1. Remove the door shelves by first pulling shelves up at a 45° angle, then straight out. 2. Remove top hinge screw pin (phillips screwdriver). Remove the door by tilting forward and lifting off the bottom hinge pin. 3....

  • Page 3

    04/2006 3 www.U-lineservice.Com 3. Attach the door panel to the overlay panel using #10 x 5/8" wood screws and nylon spacers. The nylon spacers fit between the overlay panel and the door panel as shown in figure 7. The spacers allow the original door panel to slide back into the 1/4"-thick door reve...

  • Page 4

    Www.U-lineservice.Com 4 04/2006 installing the door 1. If the cabinet already used an overlay door, there is no need to change the hinges. 2. Install the new replacement top hinge onto the unit (see figure 13). 3. Install the pivot post into the new replacement bottom hinge (using the phillips screw...

  • Page 5

    04/2006 5 www.U-lineservice.Com adjusting door alignment 1. Remove top hinge screw pin (phillips screwdriver, see figure 16). Remove door by tilting forward and lifting off bottom hinge pin. 2. With door upside-down, loosen but do not remove the two screws on the door’s bottom hinge plate. 3. See fi...

  • Page 6

    Who to call service information if the need for service arises, contact the dealer from whom the unit was purchased. State the model number and serial number and explain the problem. The model and serial number plate is located inside unit at upper right hand corner. If you need to locate a service ...