U-Line CLR2060 Installation Instructions Manual - Figure 9
c. Install the pivot post (P/N 42096) into the bottom hinge
(using the 7/64’’ hex key) and install the hinge onto the
cabinet.
d. Replace the door closure assembly onto the bottom pivot
post (see Figure 9). Be sure that bosses on closures align
with holes in hinge and hinge plate.
e. Place the modified door onto the pivot post.
f.
Position door and install the pivot post (P/N 42096) into
the top hinge (using the 7/64’’ hex key).
g. Adjust door as needed for proper closure.
h. Check to see that light switch actuator bracket is contact-
ing the light switch properly.
EXISTING DOOR
WOOD PANEL BOTTOM HINGE PLATE
(5/8" LONGER THAN EXISTING
BOTTOM HINGE PLATE)
#8-32 X 1/2" FLAT HEAD SCREW
THREE PLACES
DOOR CLOSURE TOP
DOOR CLOSURE BOTTOM
PIVOT POST
BOSS
Figure 9
Pivot posts must be cleaned. Closers must also be
clean and greased to ensure proper operation.