U-Line 2175BEVS Use And Care Manual - page 15
2175BEVS, 2175BEVOL2
15
Light Bulb Replacement
To replace the light bulb in your U-Line unit:
Figure 17
1. Grasp the edges of the light housing lens
(Figure 17, 1) opposite the exposed tab and gently
push the lens toward the tab (Figure 17, 2).
2. Pull the edge of the lens down (Figure 17, 1) and
swing it out of the light housing.
IMPORTANT
IMPORTANT
ALWAYS use a genuine U-Line replacement bulb (P/N
31317) in the light housing. Use of any other bulb
within the housing will generate excessive heat,
causing damage to the light housing and cabinet
interior, and will compromise the precise
temperature control of your unit.
3. Replace the bulb only with a genuine U-Line P/N 31317
replacement.
Replace the lens by first inserting the tab side back into the
housing at a slight angle. While gently pushing the lens
towards the tab end, push the free end up into the
housing, and release when you will hear a snap/click.
Wine Rack Removal/Installation
To remove a rack from the cabinet:
1. Grasp the end of the rack, and gently slide it out until
it stops.
2. Remove any bottles stored on the rack.
Figure 18
3. Press the left rack release lever (Figure 18) down, and
at the same time, lift the corresponding right rack
release lever up, and pull the rack out until it is free of
the tracks and the cabinet.
IMPORTANT
IMPORTANT
Do not remove the track side rails from the cabinet.
To insert a rack in the cabinet:
1. Align the left and right rack channels with the tracks
in the cabinet, and ensuring an even track
engagement on both sides, gently push the rack into
the cabinet until it stops.
2. Before reloading the rack, ensure proper operation of
the travel stops in the left and right track rails by
pulling the rack out gently until it completely stops.
Wood Trim Finishing
The U-Line Beverage Center is equipped with wood-
trimmed wine racks that are coated at the factory with a
clear vinyl sealer, which will adequately protect the wood
in normal usage. A final finish coat was not applied so
that the wood trim could be stained to match décor. The
trim on the racks may be coated with a final finish or
stained.
To remove the wood trim surrounding the controller:
Figure 19
1. Loosen the two screws holding the controller to the
mounting bracket (Figure 19, 1).
2. Lift the controller housing (Figure 19, 4) and then
rotate forward to expose the wiring harness on the
back.
3. Disconnect the wiring harness from the controller
(Figure 19, 3).
4. Remove the two screws holding in the controller
housing (Figure 19, 2), then remove from wood.
NOTE: Carefully remove controller from housing. The
glass front is not secured to the controller. Glass may fall
and break, which is not covered under warranty.
5. After staining, installation is the reverse.
Be sure to align glass with controller when installing,
otherwise controller may not work correctly.
1
2
ULIN_0001_A
ULIN_0162_A
4
ULIN_0836_A
1
2
3