1. DL manuals
  2. U-Line
  3. Refrigerator
  4. CLR1215
  5. Quick Start Manual

U-Line CLR1215 Quick Start Manual

Other manuals for CLR1215: User Manual, User Manual, Quick Start Manual, User Manual
Manual is about: 15" clear ice maker

Summary of CLR1215

  • Page 1

    Quick start guide 1000 series • clr1215 • 115 v / 60 hz.

  • Page 2

    Quick start guide u-line.Com welcome to u-line congratulations on your u-line purchase. Your product comes from a company with over five decades and three generations of premium modular ice making, refrigeration, and wine preservation experience. U-line continues to be the american leader, deliverin...

  • Page 3

    Quick start guide u-line.Com contents 1 safety and warning 1 environmental requirements 2 electrical 2 water hookup 6 drain 7 door swing 8 general installation 8 integrated panel installation 10 control operation 10 first use 10 ice 12 sabbath mode 13 warranty this quick start guide covers the basic...

  • Page 4

    Quick start guide 1 u-line.Com safety and warning notice please read all instructions before installing, operating, or servicing the appliance. Use this appliance for its intended purpose only and follow these general precautions with those listed throughout this guide: safety alert definitions thro...

  • Page 5

    Quick start guide 2 u-line.Com electrical warning ! Shock hazard — electrical grounding required. Never attempt to repair or perform maintenance on the unit until the electricity has been disconnected. Never remove the round grounding prong from the plug and never use a two-prong grounding adapter. ...

  • Page 6

    Quick start guide 3 u-line.Com caution ! Do not use any plastic water supply line. The line is under pressure at all times. Plastic may crack or rupture with age and cause damage to your home. Do not use tape or joint compound when attaching a braided flexible water supply line that includes a rubbe...

  • Page 7

    Quick start guide 4 u-line.Com 8. Install retaining clip. Outdoor models prepare plumbing the water valve uses a standard 1/4" (6.35 mm) compression fitting. U-line recommends using accessory water hook up kit – part # waterhookup. The kit includes a 10' (3 m) braided flexible water supply line and ...

  • Page 8

    Quick start guide 5 u-line.Com 1. Turn off water supply and disconnect electrical supply to product prior to attempting installation. 2. Remove the grille/access panel in the front and the back panel.Locate water valve in the front of the unit and thread water supply line through. Notice route the w...

  • Page 9

    Quick start guide 6 u-line.Com drain model numbers including “-00” or “-07” do not include a factory installed drain pump. Model numbers including “-40” or “-47” include a factory installed drain pump. Drain connection caution ! If your u-line unit did not come with a factory installed drain pump yo...

  • Page 10

    Quick start guide 7 u-line.Com factory installed drain pump if your drain line will run up to a stand pipe, disposal or spigot assembly, or does not otherwise meet the requirements for a gravity drain, you may have ordered a pre-installed u-line p60 drain pump. If you need to install a p60 drain pum...

  • Page 11

    Quick start guide 8 u-line.Com general installation leveling information 1. Use a level to confirm the unit is level. Level should be placed along top edge and side edge as shown. 2. If the unit is not level, adjust the legs on the corners of the unit as necessary. 3. Confirm the unit is level after...

  • Page 12

    Quick start guide 9 u-line.Com 8. Align door with cabinet. Tighten the top 3 screws, securing the top hinge to the cabinet. Due to differences in floor construction or surrounding cabinetry, the panel may not sit flush with the top of the door/drawer. 9. Secure integrated panel to door/drawer using ...

  • Page 13

    Quick start guide 10 u-line.Com control operation first use all u-line controls are preset at the factory. Initial startup requires no adjustments. Notice u-line recommends discarding the ice produced during the first two to three hours of operation to avoid possible dirt or scale that may dislodge ...

  • Page 14

    Quick start guide 11 u-line.Com the ice cube thickness is factory set for best overall performance. The factory setting is designed to maintain an ice bridge of approximately 1/16" to 1/8" (1.6 mm to 3.2 mm) under normal conditions, resulting in a dimple of approximately 1/4" to 1/2" (6.4 mm to 12.7...

  • Page 15

    Quick start guide 12 u-line.Com sabbath mode u-line clear ice machine models are star-k certified and can be used during the sabbath. View a full list of star-k certified u-line units at www.Star-k.Org. To prepare the unit for the sabbath: 1. Press and hold the until the unit turns off. 2. No new ic...

  • Page 16

    Warranty 30379 rev k 04.01.2017 u-line corporation (u-line) limited warranty one year limited warranty for one year from the date of original purchase, this u-line product warranty covers all parts and labor to repair or replace any part of the product that proves to be defective in materials or wor...