U-Reach Silver Fox PRO User Manual - page 10

2Function Table

10

4. Advanced

4.4 Utility

4.4.4 Quick Erase 

To erase the content of flash media. It will keep the FAT format.

4.4.5 Full Erase 

To completely bit for bit erase data of flash including format and 

content, but it takes more time.

4.4.6 System Update 

System firmware updating via the flash media.

4.4.7 Calc. Checksum

Calculate the CRC64 value of the flash media in the source port.

4.4.8 A2 Fake Picker

To check if an USB flash contains fake capacity.

4.5 Setup

4.5.1 Copy Area

4.5.1.1 System and Files

The system can automatically analyze the 

format of source data and only copy the 

data area.(Available for FAT16/32, NTFS, 

Linux (ext2/ext3/ext4) )

4.5.1.2 Whole Media

The system will copy the whole content of 

flash including the empty space.

4.5.2 Button Sound

To choose whether to hear a beep or not when a button is 

pressed.

4.5.3 Target Tolerance

To set the tolerance % of capacity gap between the source and 

target. The default setting is “No limit”.

4.5.4 Asynchronous

“Enable” to open Asynchronous function, “Disable” to close the 

function.

4.5.5 Check Before Copy

To set if you would like to check the flash media before copy.

4.5.6 Power Off Time Between Copy&Compare

To set the power-off time between Copy and Compare when 

executing “Copy+Compare” function.

4.5.7 Auto Start After Fill Device

To set if immediately start “copy/compare” tasks once plug-

ging in all targets.

4.5.8 Language

Set system language interface i.e. English, Japanese.

4.5.9 Select Speed

To select the speed of data transmission among “Fastest”, 

“Faster”, “Normal”, “Slower”, and “Slowest”. 

4.5.10 Set HDD Mode

Set if you would like to copy USB-HDD or USB drives only.

4.5.11 Advanced Setup

To change LED mode to “Traditional” or 

“Factory” mode (both on/both off).

LED in Factory-

Mode