U-Reach Silver Fox PRO User Manual - page 23

4Function Overview

23

4.2.7 Minimum Read Speed

This function can be used to select the flash media whose reading speed is too low. Users 

can set an expected minimum reading speed first when doing media check, and the flash 

media which doesn’t reach the minimum speed value will be picked out.

Use 

▲▼ button to adjust the speed limit

4.2.8 Minimum Write Speed

This function can be used to select the flash media whose writing speed is too low. Users 

can set an expected minimum writing speed value first when doing media check, and the 

flash media which doesn’t reach the minimum speed value will be picked out.

Use 

▲▼ button to adjust the speed limit

 Note:

When the Red light illuminates (Error), you can use

▲▼ to check the error information.

4.2.9 Set Capacity Check

This function can be used to set capacity range for the purpose of checking flash device. 

Users can set upper limit and then lower limit of flash capacity. Users can set upper limit and 

lower limit after entering this function. Or clear limit to reset the function.

Use 

▲▼ button to set upper limit

Use 

▲▼ button to set lower limit