Vacon X5 User Manual - page 55
X5 AC Drive User’s Manual
Chapter 5: Operation and Programming
DPD00089A
- 53 -
© 2009 Vacon Incorporated All Rights Reserved
6. Pressing the DEC key completes the store process. You will be returned to parameter 799,
and the value reverts to the default state of “disabled.”
7. Remove the memory stick. The parameter data is now stored.
5.7.2 Recalling Drive Parameters
1. Insert the memory stick in the USB port.
2. You will need to know the file name that you want to access, particularly if there is more than
one .tps file on the memory stick.
3. Access
parameter 799 (Config USB Mode)
in Level 2 programming.
4. Select Par. Recall and press the INC key.
5. The display indicates a file name, and that you should press SHIFT to proceed. Verify that
the file name is the one you wish to recall before pressing SHIFT.
6. After you have selected the file you want, press ENTER to continue.
7. Follow the prompts on the screen. When the recall is complete, the display indicates that you
should press the DEC key to finish.
8. You will be returned to parameter 799, and the value reverts to the default state of “disabled.”
9. Remove the memory stick.
5.7.3 Storing Keeper Files
1. Insert the memory stick in the USB port.
2. Access
parameter 799 (Config USB Mode)
in Level 2 programming.
3. Select Keeper Dump and press the INC key.
4. The display indicates a file name that will be stored and that you should press SHIFT to
proceed.
5. Follow the prompts on the screen. When the memory write is complete, the display indicates
that you should press the DEC key to finish.
6. The file extension for a “keeper dump” file is .csv.
7. You will be returned to parameter 799, and the value reverts to the default state of “disabled.”
8. Remove the memory stick.
5.7.4 Reflashing the X5 Using the USB Port and a Flash Memory Device
You may find it convenient to be able to reflash the X5 memory and load new software. This is
possible to do via the USB port and a memory stick to which you have copied the software.
1. On startup, press and hold the STOP key while pressing PROG to access the X5 Bootloader.
The Bootloader screen shown below appears:
2. To enter USB Reflash mode, press the PROG key. The following screen appears:
3. Insert the memory stick into the USB port.
4. Verify that you want to reflash via USB by pressing the INC key, or cancel the reflash by
pressing the DEC key.