VADDIO WALLVIEW CCU HE100 Installation And User Manual - page 6
WallVIEW CCU HE100
Quick-Connect CCU HE100 Installation and User Guide 341-789 Rev. B Page 6 of 12
Step 5:
Confirm that the CAT-5 cables are terminated correctly, by testing them with a continuity tester. Next,
connect the break out cables to the appropriate ports. The break out cable for the HE 100 has an RS-232 to
RS-422 adapter in-line, with a 1 ft. CAT-5 cable, which connects to the Controller port on the back of the
camera (see Figure 4). Secure the camera to the mount and using the ¼”-20 screws.
Step 6:
The Quick-Connect CCU interface has an 8-position dip switch on the rear panel (see page 4). Set Dip
Switch 2 to the UP position. All other switches should be in the DOWN position.
Description Dip Switch (Up = ON)
1
2
3
4
5
6
7
8
Panasonic AW-HE100
•
Setting the #2 dip switch to the UP position allows Vaddio’s
ProductionVIEW controllers and switchers to recognize the camera.
DN
UP
DN
DN
DN
DN
DN
DN
Step 7:
The Quick-Connect CCU is a 1-RU rack mount interface that breaks out the signals from the Cat. 5 cables
back to the standard connectors. The basic system connectivity is illustrated in Figure 2.
Note: Plugging the POWER CAT-5 Cable into the wrong RJ-45 may cause damage to the camera system and
void the warranty.
COMPLETING THE INSTALLATION:
Connect the Vaddio 36 VDC power supply to an AC outlet. Power will travel down the Power CAT-5 cable to
the cable shoe, powering the camera. The camera will “Home” to a centered position ready for control
information from the provided IR Remote Commander or RS-232 Camera controller of the integrators’ choice.
To insure proper continuity of control and operation of the cameras, the RS-232 controller (control system or
joystick) should be powered on after the camera.
Setting Up the AW-HE Video Format and Output Settings:
The CCU system is capable of accessing the HE 100s internal settings for format (1080/59.94i, 720/59.94,
480i, etc.) and output mode (YPbPr, RGB, Y/C). Once the camera and CCU are powered up, the
configurations can be set. The procedure is as follows:
The camera setup state is triggered by holding down the AWB and OPWB buttons on the Quick-Connect
CCU at the same time for approximately 5 seconds. The lights will blink when the setup mode is entered
and “Format/Output” will be displayed on the LCD screen of the CCU. Once the “Format/Output” is
displayed, adjusting these settings can begin.
Camera Picture Format Adjustment: Turn the Pedestal knob on the Quick-Connect CCU to scroll through
the format options of the camera, which range from 480/29.97psF to 1080/30p. Once the appropriate
resolution is displayed on the LCD screen, this is the setting that will be saved. NOTE: Not all of the
resolution options on the HE 100 will be recognized by the receiving device (ProductionVIEW HD or HD
video monitor, etc.), so be sure to select an appropriate resolution for your external device that is connected
to the Quick-Connect CCU.
Press the Auto Iris button to save the setting and “Format Saved” will be displayed on the LCD screen.
Camera Output Mode: Turn the Chroma knob on the Quick-Connect CCU to scroll through the output
options, which are RGB, YPbPr and Y/C. Once the appropriate output mode is displayed on the LCD screen,
this is the setting that will be saved (NOTE: Use only YPbPr with the Quick-Connect CCU).
Press the Auto Iris button to save the setting and “Output Saved” will be displayed on the LCD screen.