Vais Technology SL3x Owner's Manual - page 11
XM Radio controls
Presets
NOTE: Beep indicates successfully accomplished operation. If you do not hear a beep, please repeat the above steps.
@
Select the desired channel
@
Press
the [RPT] or [REPEAT] button 4 times (MUST BE DONE within 1-2 seconds). You will hear a beep.
@
SoundLinQ3 will store the current channel in the preset list. You can store up to 10 preset channels, and channels get
recorded in sequential order.
Adding a new PRESET
@
Select
preset you would like to change
@
Select new desired channel (using
the [TRACK+], [TRACK-] buttons, or use “Direct entry” on the Navigation screen
(if supported). Make sure you do not select channels which already exist in “Presets list”, because unit will move to
another preset.
@
Press the
[RPT] or [REPEAT] button 4 times (MUST BE DONE within 1-2 seconds). You will hear a beep.
@
SoundLinQ3 will update the preset list.
the
(using the
[DISC+], [DISC-] buttons)
Changing an existing PRESET
NOTE: Beep indicates successfully accomplished operation. If you do not hear a beep, please repeat the above steps.
@
Enter into “XM Radio Input Settings” Mode
@
Press the
[DISC RPT] or [DISC REPEAT] buttonone time to activatethe “DISC REPEAT” function.
@
Press the
[DISC RPT] or [DISC REPEAT] button again to deactivate it.
@
SoundLinQ3 will produce a long beep as an confirmation of successful erasure.
@
Exit “XM Radio Input Settings” Mode ( See “XM Radio Input Settings” for details)
( See “XM Radio Input Settings” for details)
Erasing PRESETS
Used to display “
Signal Strength”
Note: Will range from 0-99
Satellite Signal Strength
@
@
SoundLinQ3 will display the signal strength in position where channel number is normally displayed
@
To cancel this mode simply press [TRACK+], [TRACK-].
Press the
[SCAN] button 4 times (MUST BE DONE within 1-2 seconds). You will hear a short beep.
NOTE: Use this mode to find the proper antenna location for best reception.
XM Radio Input Settings
@
will hear a short beep as a confirmation.
@
SoundLinQ3 will use the “REPEAT” indicator (continuous blinks 2 times per second) on your head unit to confirm “XM
Radio Input Settings” Mode is active.
@
Press
the [SCAN] button 8 times (MUST BE DONE within 1-2 seconds) to exit “XM Radio Input Settings” Mode.
You will hear a short beep as a confirmation.
Press the
[SCAN] button 8 times (MUST BE DONE within 1-2 seconds) to enter “XM Radio Input Settings” Mode. You
Enter/Exit “XM Radio Input Settings” Mode
NOTE: In this mode you can setup Display Settings, Erase PRESETS list, and Adjust Sound Level for XM Radio Input
11