Vais Technology SL3x Owner's Manual - page 6
Installation
We strongly recommend that you install the unit in an easily accessible location, so you can later upgrade
the unit or re-program it in case of incorrect programming.
IMPORTANT
@
Gain access to the back of your vehicle’s Head Unit.
@
Find the same port as our Y-Harness (see “Connecting SoundLinQ3 to head unit”)
@
Disconnect the existing connector and plug in our Y-Harness connector into this port, then plug female end of Audio
Harness to plug into your factory connector .
Audio harness female connector is not used in some vehicles, in
this case isolate unused plug to prevent accidental shortage to vehicle body.
@
Plug the other end of Audio cable into designated port on this unit.
@
Connect XM Radio Receiver interface cable as shown in the picture. (see “Connecting the units”)
@
Setup proper Emulation Mode for the unit (see “Emulation Mode Selection”)
@
Turn the car on and check SoundLinQ3 functionality (especially Text capability) before the final assembly.
@
Please mount this unit in an easily accessible location for upgrading and re-programming purposes.
@
Secure the Head Unit in its original position.
Installation
Emulation Mode Selection (CD and MD changer emulation)
MD Changer Emulation Mode programming steps:
@
Properly install the unit.
@
Put both programming switches in the “DOWN” position.
@
Put ignition switch into the “ACC” position.
@
Wait for a long beep followed by a few short beeps. This may take up to one minute.
@
Return programming switches into their default position (both switches “UP”). Wait up to 30 seconds until
confirmation beep.
@
Put ignition switch into the “OFF” position. Wait at least 10 seconds.
@
Put ignition switch into the “ACC” or “ON” position.
@
Check SoundLinQ3 for functionality, especially TEXT capabilities.
CD Changer Emulation Mode programming steps:
@
Properly install the unit.
@
Put “Right” programming switch in the “DOWN” position.
@
Put ignition switch into the “ACC” position.
@
Wait for a long beep followed by a few short beeps. This may take up to one minute.
@
Return programming switches into their default position (both switches “UP”). Wait up to 30 seconds until
confirmation beep.
@
Put ignition switch into the “OFF” position. Wait at least 10 seconds.
@
Put ignition switch into the “ACC” or “ON” position.
@
Check SoundLinQ3 for functionality, especially TEXT capabilities.
!
Improper Emulation Mode setting may cause unit to be unrecognized by head unit.
!
By activating “CD or MD Changer Emulation Mode” you force the unit to find proper location in the vehicle
Audio/Video network.
IMPORTANT
6
1 2
ON
1 2
ON
Both switches
“DOWN”
Ignition into
“ACC” or “ON”
position
Both switches
“UP”
Ignition into
“OFF” position
up to 30 sec
Confirmation beep
(Red LED blinks)
Confirmation beep
(Red LED blinks)
up to 10 sec
1 2
ON
1 2
ON
Ignition into
“ACC” or “ON”
position
Both switches
“UP”
Ignition into
“OFF” position
up to 30 sec
Confirmation beep
(Red LED blinks)
Right switch
“DOWN”
Confirmation beep
(Red LED blinks)
up to 10 sec