Valeo beep & park Instruction Manual - page 5
4
5
Troubleshooting
Once reverse gear is selected, a sound signal is triggered
when there is no obstacle behind the vehicle:
1.
Check that requested height of sensors fitted on the bumper
from the floor is respected (between 45 and 60 cm).
2.
Check that requested angle of sensors fitted on the bumper is
respected If necessary, use the angle correction rings for the
installation
3.
Check that requested distance between sensors on the bumper
is respected (
4.
Check that the sensor is not installed upside-down
5.
Unplug one sensor at a time to identify the cause of the anomaly
Once reverse gear is selected, an obstacle behind the
vehicle is not detected by the system:
1.
Check that requested height of sensors fitted on the bumper
from the floor is respected (between 45 and 60 cm).
2.
Check that requested angle of sensors fitted on the bumper is
respected If necessary, use the angle correction rings for the
installation
3.
Check that requested distance between sensors on the bumper
is respected (
4.
Check that the sensor is not installed upside-down
5.
Unplug one sensor at a time to identify the cause of the anomaly
1
2
No reset
necessary
Self diagnosis
Valeo beep&park
®
system is equipped with a
self-diagnosis of sensors:
1.
When the reverse gear is selected, the system
automatically tests the 4 rear sensors
2.
If all of the sensors are working, the system beeps
once
3.
If there is a problem with any of the sensors, the
system beeps 3 times
4.
Check that sensors are properly fitted.
5.
In case of crash, you can replace the concerned
sensor by one available in the Valeo spare parts
offer (
www smileyouaredriving com)