1. DL manuals
  2. Valor
  3. Indoor Fireplace
  4. 922ECN
  5. Installation And Owner's Manual

Valor 922ECN Installation And Owner's Manual

Manual is about: PORTRAIT Decorative Vented Gas Fireplace With Coal effect fuel

Summary of 922ECN

  • Page 1

    Model 922ecn ( nat gas ) model 922ecp ( lp gas ) open front decorative vented gas fireplace (with coals) installer: leave this manual with the appliance. Consumer: retain this manual for future reference. - do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or...

  • Page 2

    2 of 19 contents 1. Safety information.........................................................................................................................................................3 2. Options ...................................................................................................

  • Page 3

    3 of 19 1. Safety information due to high temperatures, the appliance should be located out of traffic and away from furniture and draperies. Children and adults should be alerted to the hazards of high surface temperatures and should stay away to avoid burns or clothing ignition. Young children sho...

  • Page 4

    4 of 19 539 windsor arch w/ plate 2. Options # 975 zck zero clearance kit – for installation into combustible type framing. # 976 brk bedroom kit: includes optional thermostat hand set and wiring harness (for use in canada only) # 923 acf adorn cast front # 539 or 549 windsor cast arch front. (also ...

  • Page 5

    5 of 19 4. Location in the room this appliance must not be connected to a chimney flue serving a separate solid-fuel burning appliance. Note: the state of massachusetts requires that any flue damper must be removed or permanently welded in the open position. The appliance can be installed in the fol...

  • Page 6

    6 of 19 4.2 enclosures constructed using combustible materials ( z.C installations) optional # 975 zck zero clearance kit must be used when installing the 922 fireplace into any application other than as an insert into an approved solid fuel burning fireplace cavity and chimney. Complete installatio...

  • Page 7

    7 of 19 5. Supply gas model 922ecn is for use only with natural gas. Model 922ecp is for use only with propane gas. The supply pressure must be between the limits shown in section 3 of this manual. The supply connection is 3 / 8 ”npt male thread. The supply pipe connection is to a flexible connector...

  • Page 8

    8 of 19 7. Appliance preparation 7.1. Check ignition spark the pilot burner and electrode unit is at the left end of the burner. Push in the lighting knob and turn counter-clockwise through the “ign” position to “pilot”. A spark should flash across from the pilot electrode to the pilot burner shield...

  • Page 9

    9 of 19 8. Gas supply installation 1. The appliance is supplied for supply gas connection at the left hand side of the case. There is also a gas line access at he rear of the firebox for insert applications, see fig 7.The zero clearance kit does not have access at the rear. Supply line connection to...

  • Page 10

    10 of 19 9. Firebox installation ( insert application only ) 9.1 refer to 975 zck installation manual for z.C firebox installation. 9.2 to aid chimney liner connection it may be necessary to first remove the vent collar connector from the top of the firebox ( see fig 9a ) 9.3 remove the burner modul...

  • Page 11

    11 of 19 10. Remote control installation caution! Don’t connect the batteries to the remote control receiver until the wires are connected to the burner control unit, as short circuit could result in destruction of the electrical components. When installing the remote please refer to figures 10 and ...

  • Page 12

    12 of 19 11. Ceramic fuel bed installation 11.1. Ceramic walls installation 1. Locate the ceramic rear wall on top of the base coal support as shown in fig 12. 2. Insert the right hand sidewall at approx 30 degree angle between the firebox side and the burner. Swing the top of the sidewall to the ve...

  • Page 13

    13 of 19 11.2. Ceramic coals installation 1. Rest the base coal on the supports just behind the burner and let it rest against the base coal support at the back of the firebox. See fig 14. 2. Place the left front coal in position behind the metal lip at the front of the firebox. The side projection ...

  • Page 14

    14 of 19 12. #923 adorn cast front installation 12.1 carefully lift the casting. Place it against the fireplace front surface so that the retaining strip at the back of the casting is above the two upper retaining brackets at the top of the convection box. Lower the casting making sure that the rear...

  • Page 15

    15 of 19 14. #539/549 windsor arch cast front installation 14.1 all windsor arch fronts mounted to 922 fireboxes require a 540 wdk wireguard and mounting hardware, see fig 23. Note – bottom of firebox must be installed flush with the finished hearth height or casting will not install properly. Casti...

  • Page 16

    16 of 19 15. Operation checks 1. Check ignition, pilot stability, burner flames, and the full range of movement of the flame adjustment knob. See owner’s lighting instructions further on in this manual for full details, see fig 28. 2. Aeration adjustment as described in section 17, burner aeration i...

  • Page 17

    17 of 19 16. Owners information please read the safety information and notes on page 3. 16.1. Operating your fire the operating instructions are also on a chained plate inside the control access door. 1. For your safety this appliance is fitted with a flame supervision device which will shut off the...

  • Page 18

    18 of 19 16.3. Checks 1. A periodic check of the pilot and burner flames should be made. Check after the fire has been on for at least 30 minutes. The pilot flame must cover the tip of the thermocouple probe. The main burner flame pattern will vary from appliance to appliance depending on the type o...

  • Page 19

    19 of 19 your safety read before lighting warning: if you do not follow these instructions exactly, a fire or explosion may result causing property damage, personal injury or loss of life. A. This appliance has a pilot, which must be lighted by hand. When lighting the pilot, follow these instruction...