4001613-03 manufactured by / for miles industries ltd. British columbia, canada www.Valorfireplaces.Com installation & operating instructions electric coal effect fireplace dec1 installer: leave this manual with the appliance. Consumer: retain this manual for future reference. Please read this manua...
2 congratulations! We know that there are a lot of other brands that you could have purchased, and we appreciate that you have chosen a valor product. Be assured that you have not only selected a superior heater, but also superior service. Your dedicated dealer will maintain the performance and effi...
3 table of contents safety information ......................................................................................................4 specifications .............................................................................................................5 dimensions .......................
4 safety information warning: if the information in this manual is not followed exactly, an electrical shock or fire may result causing property damage, personal injury or loss of life. Important instruction when using electrical appliance, basic precautions should always be followed to reduce the r...
Specifications specifications power supply: 120 v; 15-amp grounded, circuit power cord length: 6’ (183 cm) frequency: 60 hz heater power: 1325 w net weight: 25 lb. / 11.3 kg (engine only) note: a dedicated power supply circuit is recommended for the unit but not required. Additional electrical appli...
6 fronts here are the fronts available for installation on the dimension fireplace. Innova wall mounted; partially or fully recessed classica hearth mounted with surround or mantel; wall surface mounted or partially recessed senator hearth mounted; wall surface mounted or partially recessed classic ...
7 appliance preparation checking the light bulb when handling the light bulb, avoid touching the glass with bare fingers as this will reduce the life of the bulb. Before continuing with the installation of the heater, it is important to check that the light bulb has not become loose in transit. The ...
8 the innova front is designed to be used on the dimension heater when mounted to the wall either fully recessed or partially recessed. Note: when mounting to decorative surfaces such as wall paper, care should be taken not to drag the heater down the wall as this may damage the decorative surface. ...
9 installation—classica and classic arch the classica and classic arch fronts are designed to be used on the dimension heater when installed fully recessed in a mantel or into the wall at hearth or floor level. Note: when mounting to decorative surfaces such as wall paper, care should be taken not t...
10 installation—classica and classic arch classic arch installation remove the arch from its packaging. Before fitting the arch, the hood and its baffle must be installed on the heater. Remove the upper grill panel from the heater—see figure 14. Install the hood baffle and the arch hood provided on ...
11 heater installation surface mounted the senator front is supplied with a riser and a spacer frame for use in surface mounted installations. For your safety, the frame and heater must be securely fixed to the wall. At the base of the heater, release the two screws on each side—see figure 18. Inser...
12 never cover the heater or obstruct the opening at the base of the heater; this could cause overheating and consequent risk of fire. Remote control operation on/off button to activate the remote handset, it is necessary to press the red on/off button. The status lamp on the heater will turn green—...
13 maintenance important safety before undertaking maintenance or replacing the light bulb, always disconnect the heater from the electricity supply by removing the 3-pin plug and allowing the heater to cool. Cleaning the heater and plastic parts need only to be wiped clean with a dry soft cloth; do...
14 schematic wiring diagrams l n handset fuse position if required thermistor daughterboard remote control mother board transformer heater motor thermal trip heating element effects motor 12v 0w lamp blue blue blue blue blue blue brown brown red brown heating motor heater mains terminal effects moto...
1 troubleshooting remote control does not work the batteries in the remote control handset probably need replacing—see maintenance section in this manual. The heater can be operated manually as indicated in the operating instructions section. Heater on but no light or low light this is possibly a fa...
16 spare parts list description engine classica innova classic arch senator motherboard/thermister 5129855/1848 daughterboard 5121767 transformer 5129852 lamp 5129309 lampholder 5129713 effects fan 5129853 heater fan 5129856 element 5129857 effects panel assembly 5120290 mirror assembly 130218 remot...
