Valor DEC1 Installation & Operating Instructions Manual - page 10
10
Installation—Classica and Classic Arch
Classic Arch Installation
Remove the arch from its packaging.
Before fitting the arch, the hood and its baffle must be installed on the heater.
Remove the upper grill panel from the heater—see figure 14.
Install the hood baffle and the arch hood provided on the heater with screws
provided—see figure 15.
On the rear face of the arch, below the opening, install the infill panel
provided with the front—see figure 16.
There are two magnets on the lower rear of the arch fitted on the two raised
sections. Hold the front firmly and lift into place. Keeping the magnets away
from the body of the heater, locate the front hanging brackets into those on
top of the heater—see figure 17. Lower the front into place and swing the
bottom of the front towards the heater to engage the magnets.
1.
2.
3.
4.
.
Figure 15
Figure 16
Figure 17
Figure 14
Magnet
locations
The Senator front is designed to be used on the
Dimension heater when suface mounted or partially
inserted into the wall at hearth or floor level.
IMPORTANT: With the Senator front, the engine must
use a riser supplied with the front. Consider the height
of the riser and the hearth (if any) when marking the
wall for unit position—surface mounted or partially
recessed.
Note: When mounting to decorative surfaces such as wall paper, care should
be taken not to drag the heater down the wall as this may damage the
decorative surface.
If fitting the heater onto a reflective or shiny surface such as a hearth, we
recommend that this surface does not extend further than 12” (30 cm) from
the fixing plane (wall). Reflective or shiny surfaces that project further than 12”
(30 cm) may reflect an image of the internal light bulb.
Installation—Senator
22-1/2”
(57 cm)
15-1/2”
(39 cm)
3-1/2” (9 cm)
partially recessed
Cavity minimum dimensions