Valor DEC1 Installation & Operating Instructions Manual - page 9
9
Installation—Classica and Classic Arch
The Classica and Classic Arch
fronts are designed to be used on
the Dimension heater when installed
fully recessed in a mantel or into the
wall at hearth or floor level.
Note: When mounting to decorative
surfaces such as wall paper, care
should be taken not to drag the
heater down the wall as this may
damage the decorative surface.
If fitting the heater onto a reflective or shiny surface such as a hearth, we
recommend that this surface does not extend further than 12” (30 cm) from
the fixing plane (wall). Reflective or shiny surfaces that project further than 12”
(30 cm) may reflect an image of the internal light bulb.
Mantel Clearances
Minimum depth: 6-1/2” (17 cm)
Opening dimensions: 15-1/2” W x 22-1/2” H (39 cm W x 57 cm H)
Heater Installation
Install the mantel on the wall or, if heater to be recessed, make the cavity into the
wall.
Place the heater in the mantel opening or cavity. Ensure the heater is true and
square when aligning to opening or cavity.
Drill the mantel or wall if necessary at the four fixing points—see figure 9.
Secure the heater with screws.
Classica Front Installation
Remove the front from its packaging.
Before fitting the front, the hood baffle must be installed on the heater. Remove the
upper grill panel from the heater—see figure 10.
Install the hood and its baffle provided with the front on the heater—see figure
11.
On the rear face of the front below the opening, install the infill panel provided
with the front—see figure 12.
There are two magnets on the lower rear of the front. They should rest on the
two raised sections. Ensure that they are located correctly before fitting the front.
Hold the front firmly and lift into place. Keeping the magnets away from the
body of the heater, locate the front hanging brackets into those on top of the
heater—see figure 13. Lower the front into place and swing the bottom of the
front towards the heater to engage the magnets.
1.
2.
3.
4.
1.
2.
3.
4.
.
6.
Figure 9
22-1/2”
(57 cm)
15-1/2”
(39 cm)
6-1/2” (17 cm)
fully recessed
Cavity minimum dimensions
Figure 13
Figure 11
Figure 12
Figure 10
Magnet
locations