Valor Fires 834 Installer And Owner Manual - 5. Using The Heater
Fitting the Fuel support (All models).
Before fitting the fuel support ensure that the
back page of this guide is completed.
1. Locate the fuel support as in figure 8.
2. Place the coals / pebbles on top of the fuel
support. It is not necessary to use all the coals /
pebbles supplied.
Important notes.
The coal pieces supplied are a natural material.
Occasionally it will be necessary to reduce the size
of the coal pieces. To do this place them inside a
plastic bag, place on a suitable hard surface and tap
gently with a small hammer or similar tool.
The coals / pebbles are for decorative
purposes only. There is a choke risk to young
children. Make sure they cannot gain access to
them.
5. USING THE HEATER
Important Safety
Never cover the heater or obstruct the openings at the base of the heater, this
could cause overheating and consequent risk of fire.
What are the three switches for?
The heater is operated by three switches located below the hood on the left hand side
of the heater.
Switch 1 =
O
Main On - Off
In the On position only the fuel effect operates
Switch 2 =
I
1kW fan heat setting and fuel effect
Switch 3 =
II
2kW fan heat setting and fuel effect
The switches are connected on the inside, so when switch 1 is turned off, all switches
turn off.
Page 13
INSTALLER AND OWNER GUIDE
© Baxi Heating U.K. Limited 2008.
Figure 8. Fuel support
locations (Fascia may differ
from that shown)