Valor Fires 834 Installer And Owner Manual - 4. Fitting The Heater
4. FITTING THE HEATER
The installation of this heater requires a reasonable level of DIY skills.
Please read this guide thoroughly before commencing installation and if in
doubt, seek help from a competent person.
Before fitting the fuel support ensure that the back page of this guide is
completed.
Do I need any tools?
Distinction 2 model.
A Pozidrive / Phillips / cross head. This should have a number 2 size tip. This is
required for securing the lower support bracket to the heater.
A flat ended screwdriver will be required for securing the wall mounting bracket
and lower support bracket to the wall.
If drilling into brick work you will need a power drill (preferably with hammer
action) and appropriate size drill bit for the wall plugs supplied.
Aldwyn and Panache models.
A Pozidrive / Phillips / cross head. This should have a number 2 size tip. This is
required for screwing the surround to the plinth on the Panache model and for
wall fixing on the Aldwyn model.
Where can I fit the heater?
Distinction 2 model.
The Distinction 2 model is designed to be wall mounted on a flat wall. There should
be at least 50mm (2 inches) clearance between the top of the fascia and anything
such as a shelf, fireplace surround or mantel etc. This will allow the fascia to be lifted
off or removed during servicing. To check this gently place the fascia against the
surface to which it is to be fixed. Measure the distance from the top of the fascia.
Aldwyn and Panache models.
The model is designed to be floor mounted on a level flat floor.
Page 7
INSTALLER AND OWNER GUIDE
© Baxi Heating U.K. Limited 2008.