Valor NVG-720W Owner's Manual - page 10
System Setup Menu
MAIN Menu
There are three methods to access the MAIN menu.
•Press the MENU button on the front panel .
•Press the MENU button on the remote control.
•Touch the A area on the touch-screen.
1.Touch to access Front-Zone menu.
2.Touch to access Rear-Zone menu.
3.Touch to access DVD setup.
4.Touch to access ASP setup.
5.Touch to access General setup.
6.Touch to access Screen setup.
7.Touch to turn to the previous menu.
8.Bluetooth indicator.
9.Touch to access Tuner mode.
10.Touch to access DVD mode.
11.Touch to access iPod mode.
12.Touch to access SAT Radio mode.
13.Touch to access AUX IN mode.
14.Touch to access SD Card mode.
15.Touch to access Navigation mode.
16.Touch to access Camera mode.
17.Touch to access Bluetooth mode.
18.Touch to access the Standby mode.
Note: Remote, Smart dial, touch screen operations and buttons on front panel are all useable to
select menu and adjust settings. The following instructions will show the different ways to
access menus and adjustments.
1
2
6
7
15
3
4
5
17
16
18
11
13
9
12
14
8
10
15
14
Six-Channel Audio Control
Master Volume
Front Left Channel Volume
Front Right Channel Volume
Rear Left Channel Volume
Rear Right Channel Volume
Center Channel Volume
Subwoofer Volume
Item
00 to 40
-10 to +10
-10 to +10
-10 to +10
-10 to +10
-10 to +10
-10 to +10
6-Channel Audio Adjustments
Rear Zone
If a monitor is installed in the rear zone and connected to the rear zone AV output, passengers in
the back seat can control the DVD output using the rear zone remote control. See “Rear-Zone
Remote Control” for instructions.
System Reset
To correct a system halt or other unusual operation, use the tip of a pen to press the RESET
button located on the front bottom-right corner of the unit. After a system reset, the unit restores
the settings before last power off.
Mute
The volume will be muted when the following cases occur:
• Automatic: audio output mutes when a telephone call is received by the car phone or when
verbal navigation is performed.
• When the “MUTE” wire is connected to a cell phone that will output a mute signal to the “MUTE”
Wire.
• Manual: Press the MUTE button ( ) on the front panel or the MUTE button ( ) on the
remote to mute the volume from the unit.
NOTE: Press the MUTE button again to restore the volume.
Adjusting the volume or using any of the audio set-up features will cancel the mute function.