Van Medevoort PA560 Instruction Manual - page 5
vM PA560 MULTI CHANNEL POWER AMPLIFIER
4
Controls
Precautions
Connections
Maintenance and advice
Technical
Specifications
• ONLY connect the amplifier to a (professionally installed) wall socket with earth or ground
and the corresponding voltage setting, as indicated on the back of the amplifier. Any faulty
connection will invalidate the warranty.
• To prevent damage to your loudspeakers it is advisable, both at switching ON and OFF to
turn the volume control fully to the left. Fully anti-clockwise sets the volume at its lowest level.
The same applies when changing sources.
• The correct order for ON/OFF switching of the various products is as follows:
ON: always first the source, then the pre-amplifier, followed by the power amplifier.
OFF: always first the power amplifier, then the pre-amplifier, followed by the source.
• Only connect the DC and/or RC outputs of one product exclusively to the corresponding DC
or RC inputs of the other product. Do not connect crosslink wise and also not with any audio
input or output.
• The red (+) loudspeaker terminals must never be connected with each other, with earth or
ground, or to be connected with the black (-) loudspeaker terminals
• Do make sure that there is always enough ventilation around the amplifier in order for it to
remain at its desirable temperature level.
• Do not put any magnetic devices near or on top of the amplifier, e.g. floppy disks. This can
cause irreparable damage to such devices.
• If it is necessary to replace the fuses, use only fuse(s) with the exact same value. The fuse
holders are positioned inside the amplifier and should only be replaced by an authorized Van
Medevoort Service Center. There are no user serviceable parts inside.
• If you experience any problems, always contact your nearest authorized Van Medevoort
Service Center.