Vanguard Vi33NRB Owner's Operation And Installation Manual - Installation
www.desatech.com
113195-01J
17
iNSTAllATiON
Continued
Figure 24 - Installing Log Set (Top View)
Figure 25 - Installing Screen
Notches
Screws for
Mounting
Screen
Burner
Ports
Figure 23 - Installing Log Set
Chassis
Log
Set
Crossover
Log #3
Burner
Front
Log #2
Back
Log #1
Grate
Prongs
INSTALLING LOGS
CAUTION: Do not remove the
warning and instruction labels
attached to the heater base as-
sembly. These markings contain
important warranty and safety
information.
WARNING: Failure to posi-
tion the parts in accordance
with these diagrams or failure
to use only parts specifically
approved with this heater may
result in property damage or
personal injury.
WARNING: After installa-
tion and periodically thereafter,
check to ensure that no flame
comes in contact with any log.
With the heater set to HI, check
to see if flames contact any log. If
so, reposition logs according to
the log installation instructions
in this manual. Flames contact-
ing logs will create soot.
It is very important to install logs exactly as
instructed. Do not modify logs. Only use logs
supplied with heater.
1. Place back log #1 on grate to fit as il-
lustrated in Figure 23. Make sure middle
section at bottom of log set is seated into
“U”-shaped cutout in center of chassis
(see Figure 23). IMPORTANT: Make sure
log does not cover any burner ports (see
Figure 24).
2. Place front log #2 against front grate
prongs as shown in Figure 23.
3. Place crossover log #3 on top of front and
back logs as shown in Figure 23.
4. Place lava rock around base of heater if
desired.
WARNING: You must oper-
ate this fireplace insert with the
fireplace insert screen in place.
Make sure fireplace insert screen
is in place before running fire-
place insert.