Vanguard Vi33NRB Owner's Operation And Installation Manual - Operation
www.desatech.com
113195-01J
21
OpERATiON
Continued
Note: The burner may light if hand-held re-
mote was on when selector switch was last
turned off. You can now turn burner on and off
with hand-held remote control unit.
IMPORTANT: Do not leave selector switch in
the REMOTE or ON position when pilot is not
lit. This will drain battery.
Figure 33 - Setting the Remote Selector
Switch, Control Knob and Flame
Adjustment Knob for Remote Operation
Flame
Adjustment Knob
Remote Selector Switch in
Remote Position (Optional
Hand-Held Remote Control)
Control Knob
in On Position
Figure 34 - On/Off Hand-Held Remote
Control Unit (HRC100)
ON/OFF SERIES (MODEL HC100)
Hold the control button on hand-held remote
until burner turns on. Hold the control button
again until burner turns off (see Figure 34).
To Lock press both buttons on hand-held
remote control until light stops flashing. Hand-
held remote control is now locked. If fire is on
it will be turned off automatically. In the locked
state, light will not light up when any button
is pressed.
To Unlock press both buttons together on
hand-held remote control until light stops
flashing. The hand-held remote is now un-
locked.
THERMOSTAT SERIES (MODEL
HRC200)
The hand-held remote can be operated using
either manual mode (MANU) or thermostatic
mode (AUTO) (see Figure 35). To select Fahr-
enheit/Centigrade mode display, carefully
press ˚C/˚F mode button with the end of a
paper clip or similar blunt object.
Manual Mode
1. Press POWER and LOCK buttons togeth-
er to turn on hand-held remote control.
2. Press MANU button to turn on fireplace.
3. Press POWER and LOCK buttons to-
gether to turn off fireplace.
Auto (Thermostatic) Mode
1. Press POWER and LOCK buttons togeth-
er to turn on hand-held remote control.
2. Press AUTO button to select this mode.
3. Set desired room temperature by pressing
TEMP + or - buttons.
4. Press POWER and LOCK buttons to-
gether to turn off fireplace
Note: Do not leave hand-held remote in the
AUTO mode close to fireplace. The radiant
heat from fireplace will turn off fireplace. Ide-
ally, place hand-held remote in the center of
the room facing towards fireplace.
Note: Do not hold hand-held remote for a long
time. Body temperature will affect its operation
in AUTO mode.
Figure 35 - Thermostat Hand-Held
Remote Control Unit (HRC200)
LOCK
MANU
AUTO
ºC/ºF
TEMP
POWER
ROOM
TEMP
SET
TEMP
AUTO
Turns
Hand-Held
Remote On
or Off and
Allows You
to Choose
the Manual
Setting
Digital Display Shows
Temperature and Settings
Increases and Decreases
Room Temperature in
AUTO Mode
Turns
Burners
On or Off
Locks
System to
Prevent
Accidental
Ignition
Selects Auto
Setting
Control Button
Turns Burners
On and Off
Indicator
Light