Vanguard Vi33NRB Owner's Operation And Installation Manual - Local Codes
www.desatech.com
113195-01J
5
lOcAl cODES
pRODUcT iDENTiFicATiON
Figure 1 - Log Base Assembly
Figure 2 - Fireplace Insert
Top Louver Assembly
Firebox
Hood
Bottom Louver
Assembly
Screen
Assembly
Firebox
Support
Three Piece
Log Set
Remote Selector
Switch (Optional)
Piezo
Ignitor
Optional
Remote
Control
Control
Knobs
Top Outer
Casing
Blower
Assembly
Gas Line
Access
Install and use fireplace insert with care. Fol-
low all local codes. In the absence of local
codes, use the latest edition of The National
Fuel Gas Code, ANSI Z223.1/NFPA 54*.
*Available from:
American National Standards Institute, Inc.
1430 Broadway
New York, NY 10018
National Fire Protection Association, Inc.
Batterymarch Park
Quincy, MA 02269
State of Massachusetts: The installation
must be made by a licensed plumber
or gas fitter in the Commonwealth of
Massachusetts.
Sellers of unvented propane or natural
gas-fired supplemental room heaters shall
provide to each purchaser a copy of 527
CMR 30 upon sale of the unit.
Vent-free gas products are prohibited for
bedroom and bathroom installation in the
Commonwealth of Massachusetts.
UNpAckiNG
CAUTION: Do not remove the
warning and instruction labels
attached to the heater base as-
sembly. These markings contain
important warranty and safety
information.
1. With utility knife, cut carton all the way
around above staples on bottom tray. Lift
carton off of heater. Remove packing.
Note: Hood is located in packing on right
hand side of heater front. Lift heater off
bottom tray.
2. Locate two screws above top corners
of fireplace insert screen. Remove and
discard these screws. Lift fireplace insert
screen up and pull out to remove.
3. Remove protective packaging applied
to logs, log base assembly and fireplace
insert.
4. Remove fireplace insert hood from carton
insert.
5. Check all items for any shipping damage.
If damaged, promptly inform dealer where
you bought fireplace insert.